User Account

All Pages

Calculate number of armature conductors

Assignment Help Electrical Engineering
Reference no: EM131217436

The armature of a d.c generator consists of 40 coils and each of coil has 20 turns.

When the armature is rotated at 200 rads/s in a 4-pole field structure having a flux of 5m wb/pole and there are four paths in the armature, calculate

(i) number of armature conductors and

(ii) the voltage between brushes generated by the armature.

Reference no: EM131217436

Questions Cloud

What resistance will an ohmmeter measure for that resistor : If a resistor is inserted into the breadboard with one leg at point A and one leg at point B, what resistance will an ohmmeter measure for that resistor? Why?
Find the opportunity cost of producing : a) Find the opportunity cost of producing each unit of food in terms of clothing. Explain its pattern. b) Assume we are currently producing 6 units of clothing and 4 units of food. Plot this point and interpret it economically.
Identify actions by colonies in reaction to selected act : Identify major actions by the colonies in reaction to your selected act. How did this act increase or decrease fears of an overbearing central government? What was the nature of the colonial government under crown authority?
Calculate and plot torque-speed characteristic for motor : Calculate and plot the torque-speed characteristic for this motor. (Neglect armature effects in this problem.)
Calculate number of armature conductors : Calculate number of armature conductors and Calculate the voltage between brushes generated by the armature.
Design a full adder circuit which adds three binary digits : Design a full-adder circuit which adds three binary digits xi, yi and carry in ci. Your circuit should compute the sum out si, and carry out ci as shown in given Figure.
What is the general reaction of your family to the decision : What is the general reaction of your family to this decision? Are you (or the enlisted) a part of any special population, region, minority, or other distinction?
What is environmental justice : Why differences exist in social action against environmental injustices? What characteristics related to the readings result in environemntal justice action? Why do some groups of people not mobilize, even we, as outsiders, can see clear injustice..
Plot the terminal characteristic of this machine : A 20-hp 240-V 76-A 900 r/min series motor has a field winding of 33 turns per pole. Its armature resistance is 0.09 W, and its field resistance is 0.06 W.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find what should the value of the capacitance be

A linear circuit has a capacitance of 1.0 mF and an inductor of 1.0 µH. If the frequency response of the voltage gain should stay the same and the capacitor is scaled to 70 µF, what should the value of the inductor be

  Create a ladder program for the washing machine

Create a Ladder program for this washing machine would have a fill cycle to one level, a 10 second wash cycle, a 10 second rinse cycle and then drain. Include a start button, low level switch, high level switch, an agitator motor

  Find the line- to-line voltage at the source end of the line

Two balanced three-plia.se loads that are connected in parallel are fed by a three-phase line having a series impedance of (0.4 + j2.7) ohm per phase. One of the loads absorbs 560 kVA at 0.707 power factor lagging

  Determine difference equation to generate single 852 hz tone

Using the IIR digital filter design, determine the difference equation to generate a single 852 Hz tone with a sampling frequency of 8000Hz

  Construct 4-to-16-line decoder with five 2-to-4-line decoder

Construct a 4-to-16-line decoder with five 2-to-4-line decoders (74LS139A). Use a block diagram for components and clearly show your address select variables.

  Find what is the diode current with the load connected

Design a diode voltage regulator to supply 1.5V to a 150-ohm load. Use two diodes specified to have a 0.7-V drop at a current of 10mA. The diodes are to be connected to a +5-V supply through a resistor R.

  What is the limit on the leakage resitance for the capacitor

A 100-μF capacitor is initially charged to 100V. We want 90percent of the internal energy to remain after one minute. What is the limit on the leakage resitance for the capacitor.

  What is the angular acceleration a of the cylinder

A force of 10 N is applied to a cylinder, as shown in Figure P1-1. What are the magnitude and direction of the torque produced on the cylinder? What is the angular acceleration a of the cylinder?

  The percentage of aliasing level at the cutoff frequency

The percentage of aliasing level at the cutoff frequency

  The lorentz force and behavior of current carrying conductor

You will run a simulation of Lorentz force exerted on a current carrying conductor located in the magnetic field of a horseshoe magnet. The experiment is set up so that you can change the direction of polarity of the magnet and the direction of th..

  Find the temperature at the final state of a piston-cylinder

Heat is added until the final volume is twice the initial volume. Assume that Helium behaves as an ideal gas. Use the table provided to determine the specific heats of helium and determine the following. Find the temperature at the final state.

  Use a fet for the rf amplifier

It is often preferred to use a FET for the RF amplifier in an AM receiver. Can you explain why?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd