Calculate minimum power required to operate the heat pump

Assignment Help Electrical Engineering
Reference no: EM13271319

A reversible heat pump is used to maintain the water temperature in a water heater at a constant value of 80 oC. The heat pump receives heat from its surrounding that is at a uniform 6 oC. Under steady operating conditions, cold water at 15 oC and 200 kPa enters the water heater with a flow rate of 54 kg/min and leaves the water heater at 80 oC and 200 kPa. During its operation the water heater loses heat to its surroundings at the rate of 5400 kJ/hr.

a) Calculate the rate at which heat is supplied to the water heater by the heat pump (kW)

b) Calculate the minimum power required to operate the heat pump

Reference no: EM13271319

Questions Cloud

What is the power dissipation in inverter at clock frequency : what is the power dissipation in this inverter if the clock frequency is 500MHz. Assume the supply voltage is 3V and the process is characterized by a reference inverter with tREF=20ps, CREF=4fF, RPDREF=2.5K
How fast is she going : A runner approaching the start/finish line hears the bell signaling one lap to go. The bell emits a 352 Hz tone, How fast is she going
Compare the input sequences on the two inputs : A sequential circuit hast two inputs (w1 and w2) and one output (z). Its function is to compare the input sequences on the two inputs. If w1 = w2 during any four consecutive clock cycles, the circuit produces a z=1
Find the velocity of the plane relative to the earth : A plane is headed due west with an air speed of 224 m/s. Find the velocity of the plane relative to the earth
Calculate minimum power required to operate the heat pump : Under steady operating conditions, cold water at 15 oC and 200 kPa enters the water heater with a flow rate of 54 kg/min and leaves the water heater at 80 oC and 200 kPa. During its operation the water heater loses heat to its surroundings at the ..
What is the speed of recoil of the cannon : A 10.1-kg cannonball is fired from a 3,350 kg cannon with a velocity of 198 m/s. What is the speed of recoil of the cannon
What is the total mass of the pluto-charon system : The largest moon of Pluto, Charon, was discovered in 1979. Charon is in a circular orbit of radius 19,600 km around Pluto, What is the total mass of the Pluto-Charon system
Show the thermodynamic process underwent by working fluid : Steam enters a reversible, adiabatic (isentropic) turbine at 8 MPa and 550 oC with a mass flow rate of 3.6 kg/sec. The pressure of the steam flow at the turbine exit is 250 kPa. Neglect the changes in potential and kinetic energies of the flow thr..
What is the cost of capital for this project : The debt-equity ratio is .65 and the tax rate is 40 percent. What is the cost of capital for this project?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd