Calculate drag force on flat bottom boat

Assignment Help Mechanical Engineering

Reference no: EM13701665

Calculate drag force on flat bottom boat (please show in steps).

Bottom of boat is 2m long, 1m wide

Density of water = 1000 kg/m3

Boat velocity = 0.5 m/s

Kinematic viscosity = 1.3 x 10^-6 m2/s

What power is required to keep the boat moving at 0.5 m/s?

Reference no: EM13701665

Questions Cloud

Domestic hot water supply : Steam at 500 kPa, 300 degrees C is used to heat cold water at 15 degrees C to 75 C for a domestic hot water supply. How much steam per kilogram of liquid water is needed if the steam should not condense?

Determine the response of the measurement system : A measurement system can be modelled by the equation given below, (5/8)y' +y=F(t). The output signal is initially steady at 5 V. The input signal is then suddenly increased to 8 V. Determine the response of the measurement system.

The two purposes of amplification for digital systems : The two purposes of amplification for digital systems are (i) to improve signal-to-noise ratio and (ii) to make good use of the dynamic range of the digitizer; in other words, to ensure the best resolution possible.

What is the gain required to make the digital resolution : The voltage output from a 0–50 psi pressure transducer will vary from 0–5 mV. The input/output relationship is linear. The signal will be recorded with a 12-bit A/D converter with a 0-10 V input range. The voltage output needs to be amplified before ..

Calculate drag force on flat bottom boat : Calculate drag force on flat bottom boat. What power is required to keep the boat moving at 0.5 m/s?

Find the power output in mw and the thermal efficiency : Consider a 2500 psia/1000 F turbine inlet, single reheat to 1000 F cycle with a reheat pressure ratio of P2/P1= 0.2 and a steam mass flow rate of 2 x 10^6 ibm/hr. The condensor operates at a pressure of 1 psia. Pump and turbine isentropic efficiencie..

Heat transfer involved in process closed system-ideal gas : 1 kg water in a piston cylinder device is initially at 250 degrees C and 300kpa (state 1) a total of 700 kj of work is done on the water in order to isothermally reduce its volume to 1/20 of its initial volume (state 2) determine the magnitude and th..

Assuming the temperature of the water in the system : A liter of water, initially at 30°C is placed in a refrigerator set to 5°C. Write the equation to find the time it takes a liter of water to cool 7°C, as a function of thermal resistance.

How each one is demonstrated in your communication style : Write a one-page essay that explains 2 of the 6 characteristics of interpersonal communication and illustrate how each one is demonstrated in your communication style.

User Account

All Pages