User Account

All Pages

Calculate average velocity of the water

Assignment Help Mechanical Engineering
Reference no: EM13886774

 Water ?ows in a 2-cm-diameter pipe at 10 m=s vertically upward to the center of two horizontal circular disks separated by 8 mm. It ?ows out between the disks at a radius of 25 cm. Sketch the pipe/disk arrangement. Calculate average velocity of the water leaving the disks. Also, calculate the average velocity of the water between the disks at a position where the radius of the disks is 10 cm.

Reference no: EM13886774

Questions Cloud

Calculate the mass ?ux : Water ?ows in a rectangular conduit 12-cm high and 60-cm wide having a maximum velocity of 20 m=s with the pro?les shown in Fig. 4.16. Assume the pro?le exists across the entire cross section with negligible end effects. Calculate the mass ?ux, th..
Ffirst auditing course as part of her undergraduate : Sarah O'Hann enjoyed taking her first auditing course as part of her undergraduate accounting program.
Relationship between interest rates and investment : Explain in what circumstances the relationship between interest rates and investment will be direct and in what circumstances it will be inverse.
Effects of increasing the minimum wage on employment : What do Card and Krueger find regarding the effects of increasing the minimum wage on employment? What is a possible problem with the study? Tell me an economic story that would explain their results.
Calculate average velocity of the water : Calculate average velocity of the water leaving the disks. Also, calculate the average velocity of the water between the disks at a position where the radius of the disks is 10 cm.
Calculate angular momentum of particle relative to point : A small 60 g block slides down a frictionless surface through a height cm and then sticks to the lower end of a vertical rod of mass 150 g and length 50 cm. The rod pivots about a point near its upper end through an angle θ before momentarily st..
The demand for cigarettes is price inelastic : The demand for cigarettes is price inelastic, but not perfectly inelastic. The supply of cigarettes is elastic, but not perfectly elastic. If there were no price controls or other complicating regulations, what would a model of supply and demand ther..
Height of demand curve when it intersects the price axis : On a graph of supply and demand, which of the following is represented by the height of demand curve when it intersects the price axis?
Uses two inputs-skilled workers and computers : Consider a firm that uses two inputs: skilled workers and computers. Explain what it means if skilled workers and computers are complements in production. Specifically, if the price of computers falls, and skilled workers and computers are complement..

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the temperature at which the liquid in the tank

A rigid tank with a volume of 1.8 m3 contains 15 kg of saturated liquid-vapor mixture of water at 2 bar. Now the water is slowly heated. Determine the temperature at which the liquid in the tank is completely vaporized. Show the process on a T-v diag..

  Combined hourly wage

Peter works a 12 hour day. 6 hours are no incentive and the rate is $20 per hour. He also completes 16 tasks that are incentive based and the rate is $15 per hour. How much does Peter make in his 12 hour shift and what is his combined hourly wage?

  A cyclic steam power plant is to be designed for a steam

a cyclic steam power plant is to be designed for a steam temperature at turbine inlet of 360 celsius and an exhaust

  A wheel is rotating at a uniform clockwise speed

A wheel is rotating at a uniform clockwise speed of 2 rad/s when a variable torque is applied to its shaft at time=0. As a result there is a clockwise angular acceleration which increases in direct proportion to the angle theta through which the whee..

  Asume that x0 01 m and xdot0 0 the dsplacement xt is

consider the sysstem shown in figure 3-45 where m 2 kg b 4 nxm and k 20 nm. assume that x0 0.1 m and xdot0 0. the

  Two aqueous hydrogen bromide solutions

Two aqueous hydrogen bromide solutions containing 6.00 wt% HBr (SG = 1.0402) and 65.0 wt% HBr (SG = 1.7613) are mixed to form a 2.86 molar HBr solution (SG = 1.1557).

  The freestream condition are those for a standard altitude

consider a lifting flow over a circular cylinder with a diameter of 0.5m.the freestream velocity is 25 ms and the

  A water balloon launcher uses two bungee cords each of

a water balloon launcher uses two bungee cords each of effective spring constant 125 nm stretched a distance of 0.8 m

  Oil viscosity decreases

A hydraulic system is operating at a Reynolds number of 1000. if the temp increases so that the oil viscosity decreases, would the Reynolds number, increase, decrease, or remain the same explain. Show all work and explain

  Calculate the pressure drop

The total hot water flow rate is 10 gal/min which is equally divided among 16 plates. The average temperature of hot water is 80C. Calculate the pressure drop.

  Calculate the mechanical electromagnetic damping

Consider a magnet moving in a coil of N, turns. This system can be modelled as mass spring damper system. The damping coefficient consist of both mechanical and electromagnetic damping. How can I calculate the mechanical electromagnetic damping?

  Assume the water is at constant density as it flows

liquid water enters a manifold series of pipes at 1080 psi and 125 degf with a mass flow rate of 3.5 x 10 6 lb hr and

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd