Calculate average and reactive powers delivered to the load

Assignment Help Electrical Engineering
Reference no: EM13254390

A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source. Calculate:

(a) the average and reactive powers delivered to the load,
(b) the peak current, and
(c) the load impedance.

Reference no: EM13254390

Questions Cloud

What is the current in each resistor : A 7.0 ?, a 15 ? and a 19.0 ? resistor are connected in series with a 24.0 V battery. What is the current in each resistor
Identify a possible product mix strategy : Proctor & Gamble is a multi-national, Fortune 500 company that offers a wide variety of consumer products in the areas of beauty care, household care, and health and well-being. Using this major corporation, identify a possible product mix strateg..
Define what is the mole fraction of h2 in the mixture : a gas mixture contains 4.6 g ofN2, 8.8g of H2 and 16.6g of CH4. What is the mole fraction of H2 in the mixture
Briefly describe the goods-services continuum : Briefly describe the goods-services continuum. (not the relationship marketing continuum)
Calculate average and reactive powers delivered to the load : A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source. Calculate (a) the average and reactive powers delivered to the load, (b) the peak current, and (c) the load impedance.
Increasing the capacity of the network : Increasing the capacity of the network, what would adding a T3 line do? Include the path and the protocol of the network.
What is the current in the circuit : A 6.00 V storage battery is connected to three resistors, 7.00 ?, 15.0 ?, and 20.0 ?, respec- tively. The resistors are joined in series. What is the current in the circuit
Explain what is the partial pressure of co : How do i figure out a mixture of 0.156 moles of C is reacted with 0.117 moles of O2 in a sealed,10.0L vessel at 500 K, producing a mixture of CO AND CO2. the total pressure is 0.640 atm. What is the partial pressure of CO
What are the five propositions of the davis model : What are the five propositions of the Davis model of corporate social responsibility? Which proposition would be the most valuable to you as a manager in guiding your social responsibility focus in an organization?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Which parameter has the largest impact on the output voltage

If these nominal non--ideal parameters are replaced, one at a time, by A = 50000, Ri = 1 M and R0 = 150 (each of which is twice as bad as the nominal values), which parameter has the largest impact on the output voltage

  How much charge must move through the battery

A certain battery has terminals labeled a and b. The battery voltage is vab = 12 V. a) To increase the chemical energy stored in the battery by 600J, how much charge must move through the battery

  Determine the values of the modulation index beta

a carrier wave is frequency-modulated using a sinusoidal signal of frequency fm and amplitude Am. (a) determine the values of the modulation index beta for which the carrier component of the fm signal is reduced to zero. see the appendix for calcu..

  How is the tcnt timer used to generate an interrupt

1.The S12G128 CPU board has one IRQ pin. You have four devices that will request interrupt service. How do you determine which device(s) need service 3.A communications channel has a bandwidth of 2,000 Hz and a signal-to-noise ratio (SNR) of 40 dB.

  Processor development

Explain the process of processor development

  Estimate of how to divide the amount of the project goal

the project manager on a development project working on a new line of laptop computers. The project has been broken down into the following modules: Power supply, Processor and motherboard with RAM, I/O circuit board

  Explain operational amplifier - finding the offset voltage

Operational amplifier - Finding the offset voltage, An operational amplifier has a gain of 20. The input voltage is 125mV and the input bias current is zero.

  Depiction impedance diagrams

Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.

  Discuss the differences between series and parallel circuits

Discuss the differences between series and parallel circuits. What are some advantages and disadvantages of each type Discuss why the total power equals the sum of the individual values of power, whether a series circuit or a parallel circuit is u..

  What is the corresponding incident photon flux

A solar cell is uniformly illuminated by monochromatic light of 700nm with power density of 20 mW/cm^2. What is the corresponding incident photon flux What is the upper limit to Jsc if the bandgap is 1.4eV

  What is magnitude of the current if effective current given

Calculate the following: A. What is the magnitude of the voltage in a wall socket if the effective voltage is 240 Vrms B. What is the magnitude of the current if the effective current is 360 mA rms

  Calculate the efficiency of the motors at the conditions

Based on these equations, determine the maximum power point. This is the value of and T that result in maximum power. State the power and the (,T) values. Do not assume this happens at 0.5T. The best way to do this is to make an Excel spreadsheet.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd