Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 100-mm-long, hollow iron cylinder is exposed to a 1000°C carburizing gas (a mixture of CO and CO2) at its inner and outer surfaces of radii 4.30 and 5.70 mm, respectively. Consider steady-state conditions for which carbon diffuses from the inner surface of the iron wall to the outer surface and the total transport amounts to 3.6 X 10-3 kg of carbon over 100 h. The variation of the carbon composition (weight % carbon) with radius is tabulated for selected radii.
r (mm) 4.49 4.66 4.79 4.91 5.16 5.27 5.40 5.53Wt.C (%) 1.42 1.32 1.20 1.09 0.82 0.65 0.46 0.28
(a) Beginning with Fick's law and the assumption of a constant diffusion coefficient, DC-Fe, show that dpC /d (lnr) is a constant. Sketch the carbon mass density, pC(r), as a function of lnr for such a diffusion process.
(b) The foregoing table corresponds to measured distributions of the carbon mass density. Is DC-Fe constant for this diffusion process? If not, does DC-Fe increase or decrease with an increasing carbon concentration?
(c) Using the experimental data, calculate and tabulate DC-Fe for selected carbon compositions.
A sheet of cold worked copper has a ductility of 15%. If the sheet thickness is 3.4 mm, what were the dimensions of the cross-section before rolling?
a thin-walled tube is subjected to an axial force of 40 kn. if the tube elongates 3mm and its circumfrence decreases
a one shell two tube pass surface condenser is required to handle the exhaust from a steam turbine developing 14 300 kw
a good aluminized layer is desired to be achieved by dipping clean steel in hot molten aluminum. for al to adhere to
on an assembly line that fills 8-ounce cans a can will be rejected if its weight is less than 7.90 ounces. in a large
The lamp has a mass of 15 kg and is supported by a pole AO and cables AB and AC. If the force in the pole acts along its axis, determine the forces in AO, AB, and AC for equilibrium.
problem 1 a 10-minute experimental run shows that 75 of liquid reactant is converted to product by a half-order rate.
A uniform linear charge density of 4 nC/m is distributed along the entire x axis. Consider a spherical (radius = 5 cm) surface centered on the origin. Determine the electric flux through this surface.
What is the wear coefficient of the bearing material in m2N-1 ?
a piston cylinder device contains 2.5 kg of carbon dioxide co2 initially at 100 kpa and 300 degrees celsius.the co2 is
A frictionless piston cylinder device arrangement initially contains 8kg of saturated water mixture at 200 Degrees Celsius. Heat is supplied to the mixture till all the mixture is converted to saturated vapour at constant pressure. Determine the fina..
An air-standard Otto cycle has a compression ratio of 6. At the beginning of compression, the pressure is 100 kPa and the temperature is 300 K. During the heating process, the temperature is raised to 2500 K. Assume that the cold air-standard assumpt..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd