Calculate air flow required in cfm to transfer in hvac duct

Assignment Help Civil Engineering
Reference no: EM13299611

Calculate the Air flow required in CFM to transfer 5,004 BTU/Hour in an HVAC duct given that the temperature difference (Delta-T) between the room and the supply air is 23 DegF.

Reference no: EM13299611

Questions Cloud

Essay on management and organization : Essay on management and organization
Determine the downward deflection of the tray center : A tray rests on an extendible arm consisting of two steel tubes with two different outer diameters. The downward force at the tray center F0 = 1000 N. Determine the downward deflection of the tray center and the tilt angles of the tray about each ..
Discuss the advantages and disadvantages of attached growth : Biological treatment processes for wastewater can be catogarised as dispersed growth and attached growth systems. Discuss the advantages and disadvantages of attached growth systems over dispersed growth systems.
Current international marketing issues : Current international marketing issues facing businesses operating between countries.
Calculate air flow required in cfm to transfer in hvac duct : Calculate the Air flow required in CFM to transfer 5,004 BTU/Hour in an HVAC duct given that the temperature difference (Delta-T) between the room and the supply air is 23 DegF.
Draw p-v dia for pure component and label appropriate point : Draw a P-V diagram for pure component and label appropriate points such as superheated region, isothermal line, etc.
Review the financial statements of merck and novartis : Review the financial statements of Merck and Novartis to learn additional information. The emphasis of this Case is to review the income statement, balance sheet and computation of ratios.
Work life balance is only meaningful to the work-shy : Work life balance is only meaningful to the work-shy and those lacking ambition Do you agree or disagree on this statement? explain your reasoning.
Determine the amount of energy added to the water : A mass of 200g of saturated liquid water is completely vaporized at a constant pressure of 100KPa. Determine a) the volume change b) the amount of energy added to the water

Reviews

Write a Review

Civil Engineering Questions & Answers

  What maximum load can be applied tot the center of the beam

A simply supported steel 'I beam' is made of three 1"*8" plates with a mass of 898.4 lbmass each as shown in I beam form. Steel has a modulus of elasticity of 30*10^6 psi. The beam is allowed to deflect 1.05 inch.

  Find the required width of the footing using terzaghis shear

The footing is supported to carry a net safe load of 400 kN/m^2 with FS = 3. Given Ysat = 20.85 KN/m^3 and phi = 35 degrees, find the required width of the footing using Terzaghi's general shear failure criterion.

  Magnitudes of fac and fad

The 70 m tall tower is supported by three cables that exert forces FAB, FAC, and FAD on it. The magnitude of the force FAB is 2 kN. The x and z components of the vector sum of the forces exerted on the tower by the three cables are zero. What are ..

  Determine estimated unknown speed if the data were obtained

In an attempt to estimate the speed of a vehicle just before it hit a traffic signal pole, a traffic engineer measured the length of the skid marks made by the vehicle and performed trial runs at the site to obtain estimate if the coefficient of f..

  Width of the second floor-cross section of a cottage

A cross section of a cottage, 20 ft wide, is an isosceles triangle. If the slope of a side is 1.75 and there is a second floor 8 ft above the ground floor, what isthe width of the second floor?

  Draw to scale the expected streakline of the stream

The following wind conditions are expected: V = 10 i - 5 j mph for 0 10 hr. Draw to scale the expected streakline of the stream  for t = 3, 10, and 15 hr.

  Oxidization of ammonia during nitirification

what is the final dissolved oxygen concentration (in mg/L) in the waste lagoon after all of the ammonium (NH4 + ) is converted to nitrate? Recall that 4.57 mg of O 2 is need per mg of ammonium (as N) oxidized during nitirification. After all of the..

  Calculate pi if sample falls with the control charts limits

A sample with a measured background level (Bi) of 22 mg/l was spiked with the equivalent of 30 mg/l without appreciably changing the sample volume. The result for the spiked sample (Ai) was 49.2 mg/l. Calculate Pi and determine if it falls with th..

  Find summer values for oxygen tranfer-hp and airflow rate

A fine-bubble aeration basin has a flow of 21.5 mgd, an influent BOD of 180 mg/l, 31 mg/l of mmonia, and effluent of 10 mg/l. During the winter, the wastewater temperature of 14.8 degrees C does not nitrify.

  Time inventory system for a product

How appropriate might a just in time inventory system be for a product such as roller skates?

  Supporting Investment Promotion: ERNST & YOUNG

Ernst & young is currently providing support to various sectors. In this regards it was felt that if this report is able to document good practices currently being adopted or planned in ceramic sector.

  How much was the initial investment at an interest rate

A company that manufactures regenerative thermal oxidizers made an investment 10 years ago that is now worth $1,300,000. How much was the initial investment at an interest rate of 15% per year (a) simple interest and (b) compound interest?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd