Basic bonding and atomic models

Assignment Help Mechanical Engineering

Reference no: EM13718967

Explain the answer in a manner such that someone who did not previously know the answer will now understand the concept down to the microscopic level (i.e., basic bonding and atomic models).

1. Explain how, when cold working a material, it is possible to increase the material's yield such that it exceeds the original (unworked) material's ultimate tensile strength.

Reference no: EM13718967

Questions Cloud

Determine the final mass of the tank : An insulated rigid tank contains 5 kg of helium gas at 440 kPa and 31C. A valve is now opened, and helium is allowed to escape until the pressure inside drops to 200 kPa. Assuming the helium remaining inside the tank has undergone a reversible, adiab..

Pressure driven flow between stationary parallel plates : Consider the pressure driven flow between stationary parallel plates separated by distance b. Coordinate y is measured from the bottom plate. The velocity field is given by u=U(y/b)[1-(y/b)]. Obtain an expression for the circulation about a closed co..

Rigid tank is divided into two equal parts by a partition : An insulated, rigid tank is divided into two equal parts by a partition. Initially, one part contains 6.06 kmol of an ideal gas at 155 kPa and 30C, and the other side is evacuated. The partition is now removed, and the gas fills the entire tank. Dete..

Dual cycle has a compression ratio : A Dual cycle has a compression ratio of 15:1. The state at the beginning of compression is 14.4psi and 60F. The volume ratio during the constant pressure part of the heat addition process is 2:1. The pressure ratio during the constant volume heat add..

Basic bonding and atomic models : Explain the answer in a manner such that someone who did not previously know the answer will now understand the concept down to the microscopic level (i.e., basic bonding and atomic models).

Find the velocity at which the water jet hits the ball : The 0.15 kg ball is held stationary by a jet of water. At the nozzle, the speed of the jet is 6m/s, and its diameter is 12mm. Find the velocity at which the water jet hits the ball and the height of the ball. Density of water is 1000kg/m^3

Calculate the maximum work that this turbine can produce : Air at 3.5MPa and 500 C is expanded in an adiabatic gas turbine to 0.2MPa. Calculate the maximum work that this turbine can produce, in kJ/kg.

Intake entry of the tract to the head of the inlet valve : Determine the total induction length, from the point of intake entry of the tract to the head of the inlet valve, to optimize the wave ram effect at the following engine speeds:

Power plant uses the ranking cycle : A power plant uses the ranking cycle. the maximum desired temperature in the boiler is 500C. If the turbine is reversible, and the outlet of the turbine (input to condenser) is saturated vapor at p=25kPa,

User Account

All Pages