Reference no: EM13963115
Question 1.
a. Which is better for transmission of electric power over long distances: DC low voltage or AC high?
b. Where in the Washington DC area is there a statue of Joseph Henry
c. What is the SI (MKS) unit of inductance?
d. Write an equation for the terminal relationship for an inductor?
e. Write an equation for the energy stored in an inductor
f. An inductor has a terminal voltage v(t) = V0Cos (t). What is the voltage phasor?
g. A passive circuit element has the following voltage and current signals across its terminals: v(t) = 2000cos(30t) and i(t)= 10sin(30t). Is the element a capacitor, inductor or resistor?
h. Write the phase difference between the voltage and current across a load with impedance Z = 2+2j Ohms under AC steady state conditions?
Question 2.
In answering the following questions please refer to the curves a-I above.
a. Voltage across a capacitor has the time dependence which looks like curve d. Which curve could represent the time dependence of current through the capacitor?
b. Current through a resistor has the time dependence which looks like curve g. Which curve could represent the time dependence of voltage across the resistor?
c. Voltage across an inductor has the time dependence, which looks like curve i. Which curve could represent the time dependence of current through the inductor?
Question 3.
On the schematic shown below, two voltages and two currents are given.Find all of the other voltages and write them in the rectangles next to the resistors.
Question 4.
For t > 0 the voltage across a 1F capacitor is given by the expression
where t is the time in seconds.
a) Calculate the current flow in the capacitor, and sketch a graph of your answer
b) Calculate the instantaneous power flow in the capacitor, and sketch a graph of your answer
c) At what time is the instantaneous power flow maximum
d) What is the energy stored in the capacitor for t = 2 seconds.
Question 5.
Consider the circuit shown on the left with vs1 (t) = 50 sin (t) and vs2(t) = 30 sin (t) and frequency 1 kHz.
a) Write the KCL and KVL equations for the circuit in phasor form. (Cleary label your diagram)
b) Calculate the current phasor for is1(t).
c) Calculate is1(t)
Question 6.
A load that consists of an inductor, resistor, and a capacitor is connected across a voltage source between points A and B, as shown on schematic below. The voltage source produces sinusoidal signal with amplitude of 10 Volts at a frequency of 200 Hz.
For this load, calculate the
a. current,
b. power factor
c. average power dissipation.
Attachment:- exam1.1.doc
|
Details of the new debt issues
: STL has asked you for advice on putting together the details of the new debt issues it is planning to make. What information would you need to obtain to provide this advice?
|
|
Optimal debt ratio-cost of capital
: It had a beta of 1.30, and the interest rate on its debt is 8 percent (the Treasury bond rate is 7 percent). If it moves to its optimal debt ratio of 40 percent, the cost of capital is expected to drop by 1 percent.
|
|
Estimate the debt ratio for iou
: The firm has a beta of 1.20, and the current Treasury bond rate is 7 percent. Assuming that the operating income will increase 10 percent a year for the next five years and that the firm's depreciation and capital expenditures both amount to $100..
|
|
Percent of the outstanding stock every year
: Estimate the debt ratio each year for the next five years, assuming that the firm maintains it current payout ratio. Estimate the debt ratio each year for the next five years, assuming that the firm doubles its dividends and repurchases 5 percent of..
|
|
At what time is the instantaneous power flow maximum
: On the schematic shown below, two voltages and two currents are given.Find all of the other voltages and write them in the rectangles next to the resistors.
|
|
Develop hypothesis statements based on the research question
: Create a 350- to 700-word real or realistic scenario for the introduction based on the company selected and the two variables.Include a background, a business problem, and the team's role. Create a research question based on the two variables. Deve..
|
|
Establish the values of k for which the binomial coe?cient
: Establish the values of k for which the binomial coe?cient p Ck is divisible by p when p is a prime number. Use your result and the method of induction to prove that np - n is divisible by p for all integers n and all prime numbers p. Deduce that ..
|
|
Firm plans to increase its leverage instantaneously
: Assuming that the firm plans to increase its leverage instantaneously, what are some of the approaches it could use to get to 50 percent? Is there a difference between repurchasing stock and paying a special dividend? Why or why not?
|
|
What was the ratio for justice deanes decision
: What was the ratio for Justice Deane's decision in favour of Mr and Mrs Amadio - How was it different from the ratio adopted by Justice Gibbs?
|