At what angular speed does the bar-clay system rotate

Assignment Help Electrical Engineering
Reference no: EM13269983

On a frictionless table, a glob of clay of mass 0.220 kg strikes a bar of mass 0.600 kg perpendicularly at a point 0.150 m from the center of the bar and sticks to it. If the bar is 1.380 m long and the clay is moving at 8.700 m/s before striking the bar, at what angular speed does the bar/clay system rotate about its center of mass after the impact (in rad/s)?

Reference no: EM13269983

Questions Cloud

Explain numbers of electrons in the outer or valence : For which elements (main group or transition) do the numbers of electrons in the outer or valence, shell correspond to the group number
What was the original frequency of the guitar string : A violin string tuned to 485.0 Hz is found to exhibit 3.5 beats per second with a guitar string. What was the original frequency of the guitar string
Guilty escape punishment and support your position : Take the position that suppression of evidence leads to injustice as the guilty escape punishment and support your position.
Depict a titration curve of ph with respect to a dual axis : Draw the structure of the peptide in its predominant ionic form at a)pH 2; and b) pH 8 and determine its net charge at the specified pH values c) draw a titration curve of PH with respect to a dual axis with the equivalents of HCl added and the ne..
At what angular speed does the bar-clay system rotate : On a frictionless table, a glob of clay of mass 0.220 kg strikes a bar of mass 0.600 kg perpendicularly at a point 0.150 m from the center of the bar and sticks to it. If the bar is 1.380 m long and the clay is moving at 8.700 m/s before striking ..
What is the speed of light in this condensate : In an ultra-low-temperature experiment, a collection of atoms enter a special state called a Bose-Einstein condensate, What is the speed of light in this condensate
Explain what is the empirical formula for this compound : A sample of an unknown biochemical compound is found to have a percent composition of 45.46% carbon, 7.63% hydrogen, 10.60% nitrogen and the balance oxygen. What is the empirical formula for this compound
What force acts on the mirror : A parallel beam of light with an energy flux S of 10 W/cm2 falls for 1 hour on a perfectly reflecting plane mirror of 1.0 cm2 area. what force acts on the mirror
During this type of immune system response : During this type of immune system response, the body's defense system literally eats invading pathogens

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the modulation used to transmit hdtv signals

What is the modulation used to transmit HDTV signals over the air in US terrestrial broadcasting? What is the transmitted bit rate and the compression method?

  What is the speedup have obtained from fast mode

Assume that we make an enhancement to a computer that improves some mode of execution by a factor of 10. Enhanced mode is used 50% of the time, measured as a fraction of the execution time when the enhanced mode is in use.

  Determine e0 and write an expression for e at time t

A y polarized UPW motion in + x direction in free space has a maximum value of 20 (V/m) at a point x=1.5 (m) with the next adjacent minimum at x=2.75 (m) at time t=0 Obtain the wavelength and the frequency of the wave.

  Identify and discuss the issues involved in govt laws

A new government law requires that the lead content of drinking water be less than 1.0 ppb. You are a safety engineer, and you have recently tested your companys drinking water using two methods. Method A gives a reading of 0.85 ppb

  Calculate the total power draw by the two loads

Two delta-connvected loads are connected in parallel and powered by a balanced Y-connected system. The small of the two loads draws 10k VA at a lagging Power Factor (PF) of 0.75, and the larger draws 25k VA at a leading PF of 0.80.

  Explain binary symmetric channel

Binary symmetric channel, Assume that we are transmitting binary digits over a binary symmetric channel. Let p(x=0)=p(x=1)=0.5.

  Explain what should the signal definitions be

What should the signal definitions be for the equations, such that the minimal about of hardware (gates) are used assuming we have an abundance of NAND gates Show the signals definitions and resulting circuitry.

  Calculate voltage regulation and efficiency of the line

A 3-phase transmission line series load of 2000MVA, .8 p.f. lag at 735 kv. The ABCD parameters of the line are : A = .8746 =D, B = j128.33Ω, C = j.0018315 (s). Calculate Vs, Is, voltage regulation and efficiency of the line.

  Define frequency divider

Important information about Frequency Divider, Design a frequency divider circuit that will output three pulse frequencies: 25 kHz, 10kHz, and 2.5kHz. Assume that only a 150 kHz CMOS compatible signal is available for the divider input

  Determine the value of c in microfarads

you have a RC circuit with an unknown capacitor. You have a 20V source and a 33k ohm resistor. the question states. The voltage Vc for the network has risen to 16V 5seconds after the switch was closed. Determine the value of C in microfarads.

  Determine the frequency and the period of function

Let x(t) = cos(3/4(t+1/2)+1/4) a. Determine the frequency, the period of x(t) b. Given another signal, y(t)= sin(3/4(t+1)+3/8), is y(t) identical to x(t) Why

  Compute the bit error probability for both constellations

2. Compute the symbol error probability for both constellations in terms of the Gaussian error integral Q(x). 3. Compute the bit error probability for both constellations in terms of the Gaussian error integral.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd