At what air speed should the model test be performed

Assignment Help Civil Engineering

Reference no: EM131310529

The drag on a 2-m-diameter satellite dish due to an 80 km/h wind is to be determined through wind tunnel testing on a geometrically similar 0.4-m-diameter model dish.

a. At what air speed should the model test be performed?

b. If the measured drag on the model was determined to be 170 N, what is the predicted drag on the full-scale prototype?

Reference no: EM131310529

Questions Cloud

Determine the composition of the exiting liquid stream : Determine the composition of the exiting liquid stream; the ratio of the actual Ls/Gs is larger than the minimum Ls/Gs.

How long will it take the object to reach its maximum height : MATH233 Unit 2: Polynomial Functions- How long will it take the object to reach its maximum height? How long will it take the object to hit the ground? What is the velocity of the object when it hits the ground?

Find the maximum possible spacing between pumping station : The crude oil has SG = 0.93, and its viscosity at the pumping temperature is μ = 0.017 Ns/m2. For these conditions, determine the maximum possible spacing between pumping stations.

What decides to use tcp or udp : Network switches provide essential connectivity in local and wide area networks. Some of them run in multilayer between layers 2 and 3. What protocol unit is being used in layer 2?The backbone of the Internet is structured by the Internet Protocol ..

At what air speed should the model test be performed : The drag on a 2-m-diameter satellite dish due to an 80 km/h wind is to be determined through wind tunnel testing on a geometrically similar 0.4-m-diameter model dish.

Determine the moles of water that are required per mole : Determine the moles of water that are required per mole of H2S-free carrier gas if 1.5 times the minimum ratio will be used.

How fast must the wing move through the air : How fast must the wing move through the air at an altitude of 35,000 ft if it is to generate the same lift? (Assume the lift coefficient is constant.)

Simulate the deposits made to a fictitious bank account : In this programming assignment you will simulate the deposits and withdrawals made to a fictitious bank account. In this case synchronized threads will make the deposits and withdrawals.

Determine moles of steam if countercurrent tower is used : A wash-oil flow rate of 6.94 mol/s will be used.- Determine the required moles of steam if a countercurrent tower is used; a cocurrent tower is used.

User Account

All Pages