Assuming the water heater acts as a heat sink having an

Assignment Help Mechanical Engineering
Reference no: EM13638235

Cold water at 10°C enters a water heater at the rate of 0.02 m3/min and leaves the water heater at 50°C. The water heater receives heat from a heat pump that receives heat from a heat source at 0°C.

(a) Assuming the water to be an incompressible liquid that does not change phase during heat addition, determine the rate of heat supplied to the water, in kJ/s.

(b) Assuming the water heater acts as a heat sink having an average temperature of 30°C, determine the minimum power supplied to the heat pump, in kW.

Reference no: EM13638235

Questions Cloud

The reheat pressure is varied from 125 to 05 mpa determine : using ees or other software investigate the effect of reheat pressure on the performance of an ideal rankine cycle. the
At some temperaturethe reaction is pcl5g regpcl3gcl2g if : at some temperaturethe reaction is pcl5g regpcl3gcl2g. if 0.10mol of pcl5 are added to a 1-l flask and 0.020 mol of
Two stationary positive point charges charge 1 of magnitude : two stationary positive point charges charge 1 of magnitude 3.35 and charge 2 of magnitude 1.55 are separated by a
A six-sided dice is tossed once and its outcome is noted it : 1. a class consists of 10 juniors 10 seniors and four graduate students. agroup of six students is selected at random
Assuming the water heater acts as a heat sink having an : cold water at 10degc enters a water heater at the rate of 0.02 m3min and leaves the water heater at 50degc. the water
She concludes correctly that the table is not level and : a physics student playing with an air hockey table a frictionless surface finds that if she gives the puck a velocity
The market price for a certain product is 5 per unit and : the market price for a certain product is 5 per unit and occurs when 14000 units are produced. at at price of 1 no
Suppose an unfair coin comes up heads 368 of the time if : suppose an unfair coin comes up heads 36.8 of the time if it is flipped. if the coin is flipped 11 times what is the
A fire clay brick rho 2000 kgm2 k 10 wm-k cp 800 jkg-k : a fire clay brick rho 2000 kgm2 k 1.0 wm-k cp 800 jkg-k of dimensions 5 cm by 10 cm by 15 cm is removed from a kiln

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  What weight lbsgal drilling mud would be required to

1. if the average density of the sediments in the gulf of mexico is 2.17 gmcc and the water depth at the wellsite is

  A car with a mass of 1570 kg is supported by four springs

a car with a mass of 1570 kg is supported by four springs each with a spring constant of 25 nmm. in traveling over an

  The pressure is p110psi and at section 2 it is at standard

consider a flow of air in a duct assume standard atmospheric pressure at 5000 ft altitude p12.228psi. at section 1 the

  Question 1 entropya in a coal fired thermal power station

question 1 entropya in a coal fired thermal power station indicate where the exergy contained in the coal is destroyed.

  Determine the stream ecomomy of the system assume that the

feed at 10 ccelsius containing 20 solids enters an evaporator operating at 90 ccelsius. saturated steam90 quality

  However test conditions limit the available power to 400 kw

axial flow coolant pump for one lop pressurized nuclear reactor has 75 m head 6m3s flow rate 1440rpm 800 mm diameter

  If the inlet axial mach number is 52 calculate the mean

a high pressure axial compressor for a jet engine rotates at 15000 rpm with an overall stagnation pressure ratio of

  Aditional heat is added until the pressure reaches 12 mpa

two kilograms of water are contained in a pistoncylinder arrangement. the massless piston is loaded with a linear

  A stirring rod transfers energy by work until the pressure

a closed rigid tank well-insulated contains air initially at 1 bar 300 k. the volume is 2 m3. a stirring rod transfers

  Superheated steam at 15 mpa and 600 c enters the turbine of

superheated steam at 15 mpa and 600 c enters the turbine of a steam power plant and is expanded to an exit pressure of

  Knowing that p 75 n and q125 n determine graphically the

tow forces p and q are applied as shown at a point a of a hook support. knowing that p 75 n and q125 n determine

  Find the equation for max stress and strain in the beam at

uniform beam with 2 supports has a total length l. pinned at a and roller at b. force f is applied at the center of the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd