Assume steady state operation and kinetic and potential

Assignment Help Mechanical Engineering
Reference no: EM13644163

Water is the working fluid in as ideal Rankine cycle. Saturated vapor enters the turbine at 16 MPa (state 1) and the condensed pressure is 8 kPa. The mass flow rate of steam entering the turbine is 120 kg/s. Assume steady state operation and kinetic and potential energy effects are negligible. Determine:

a. Show cycle on T-s Diagram
b. the net power developed, in kW
c. the rate of heat transfer to the steam passing through the boiler, in kW
d. the thermal efficiency.

Reference no: EM13644163

Questions Cloud

Assuming that air contains 78 n2 21 o2 and 1 ar all by : assuming that air contains 78 n2 21 o2 and 1 ar all by volume how many molecules of each type of gas are present in 1l
In one case pressure is raised at tconstant then t is : water is heated from 100kpa 20 deg c to 1000kpa 200 deg c. in one case pressure is raised at tconstant then t is raised
What is the probability that a randomly selected student : suppose that the amounts that students at a college spend on textbooks this semester have a normal curve with mean ? mu
What is the ionization energy of rubidium atoms in : the ionization energy of an atom can be measured by photoelectron spectroscopy in which light of wavelength is directed
Assume steady state operation and kinetic and potential : water is the working fluid in as ideal rankine cycle. saturated vapor enters the turbine at 16 mpa state 1 and the
The exit conditions are 10 kpa with a quality of 9 : steam flows steadily through an adiabatic turbine. the inlet conditions ar 10 mpa 450 degrees c 80 ms and inlet area of
A 1000 ml portion of hcl sol was diluted to 5000 ml if 500 : a 10.00 ml portion of hcl sol was diluted to 50.00 ml. if 5.00 ml of this solution required 41.00 ml of 0.2550 m sodium
It enters the regenerator with an effectiveness of 075 it : a regenerative brayton cycle has two step isentropic compression with cooling. air enters the first compression at 300
Steam from a boiling teapot 100 degc hits a persons hand : steam from a boiling teapot 100 degc hits a persons hand and causes a burn. assuming 1 g of water vapor condenses to

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Two charges -18 c and 49 c are fixed in place and separated

two charges -18 c and 4.9 c are fixed in place and separated by 4.2 m. a at what spot along a line through the charges

  What torque must be applied to the shaft to overcome the

1 a 500 ml cylindrical mug is filled level with the top of the mug with 90degc water. what is the water level relative

  Determine the size of the equipment

Building HVAC Requirements - Indoor Air Quality and Mechanical Ventilation and how determine the size of the equipment if i need for 60cfm.?

  If a light bulb bought from a particular store has a 18

if a light bulb bought from a particular store has a 1.8 probability of being defective when it leaves the store

  Such a cylinder with a 3in diameter piston and 2in

a double-rod cylinder is one in which the rod extends out of the cylinder at both ends. such a cylinder with a 3in

  Use work and energy to determine the center of mass

bar ab of mass m and mass moment of inertia i 112ml2 is constrained to move within the channel as shown. the bar is

  Water is pump from a lake to a storage tank at 18m above at

water is pump from a lake to a storage tank at 18m above at a rate of 70 ls while consuming 20.4 kw of electric power.

  Find the centroid and moment of inertia ix of a composite

find the centroid and moment of inertia ix of a composite steel structure. the structure is built out of a 2 thick by

  Determine the mass flow rate

(a) Draw and label a schematic of the system. (b) Determine the mass flow rate (kg/s) of water vapor neededand (c) the rate of exergy destruction (kW)

  Find the work done if the pressure between the initial and

a system has an initial volume of 10 ft3 and expands to a final volume of 20 ft3. the initial pressure is 15 psia. find

  The 4 in diameter brass shaft shown is fixed at end a and

the 4 in diameter brass shaft shown is fixed at end a and fastened securely to a rigid horizontal member at end b.

  Assume no temperature change during the pumping and find

an air pump with a 4-in piston and a 12-in stroke compresses atmospheric air into a 5ft3 evacuated tank. assume no

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd