Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
DISCUSSION
The group found that each sample's hardness was affected when subjected to heat treatment with natural aging. It was found that the hardness of the samples decreased a significant amount directly after being removed from the oven because of not fully cooling but the values began to naturally age and the hardness values increased. Artificial aging of the samples proved to be most effective with the samples that were heated, immediately quenched, and then aged for the week after. The two steel samples that were quenched in water after being heated for 30 minutes experienced a larger increase in hardness. The group believes this is because the cooling effect caused the initial softer material to transform to a much harder, stronger material. Some possible sources of error for the natural aging metals could have come from the fact that no data was collected over the weekend and therefore not having a full week. Also, the oven was constantly being opened and closed for the metals that were being artificially aged and this could decreased the temperature from its set 370°F. One final source of error could have been with the sanding and it not being consistently grinded with all of the samples.
CONCLUSIONS
After days of testing the samples the hypothesis was proven to be correct. The natural aging process had the higher from the artificial aging on the materials, and the steel 1075 had the higher hardness value than the aluminum 2024.
a car with a mass of 1480 kg is constructed so that its frame is supported by four springs. each spring has a force
1 water at 15 degrees celcius flows through a nozzle that contracts from a diameter of 10cm to 2cm. the exit speed is
Finding Metal Removal Rate In an electrochemical machining operation, the frontal working area of the electrode is 2.5in squared
A 5v belt drive system operates an input speed of 1250 RPM at the small sheave. The driving sheave has a pitch diameter of 6.000 in, and the driven sheave has a pitch diameter of 19.000 in.
a three-span continuous beam abcd with three equal spans supports a uniform load of intensity q. determine all
Create parts and assembly of the Tool Post shown in the figure. Remember to profile and constrain (add dimension) your sketch for each model. Use appropriate solid modeling techniques and 3-D constraints as necessary.
Determine the amount of steam produced per hour, if the total heat loss is 10% of the heat available for steam raising - What would be the new heat transfer area if the fluids were in parallel flow
two small metal spheres with masses 2.0 g and 4.0 g are tiedtogether by a 5.20 -long massless string and are at rest on
air flows in a horizontal cylindrical duct of diameter d 100 mm. at a section a few meters from the entrance the
steam enters a steady flow turbine at 30mpa 1000degc with a flow rate of 10kgs. thirty percent of the inlet mass of
Define the main structural characteristics of a pin joint and describe an existing structure where such joints are used and why.
A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 3 MPa and 50 kPa. The temperature of the steam at the turbine inlet is 300 C and the mass flow rate of steam through the cycle is 35 kg/s. Show the cycle on a..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd