An attack helicopter is equipped with a 20mm cannon tat

Assignment Help Physics
Reference no: EM13632432

An attack helicopter is equipped with a 20mm cannon tat fires 112 g shells in the foward derection with a muzzle speed of 743 m/s. The fully loaded helicopter has a mass of 1630 kg. A burst of 238 shells is fired in a 3.99 s interval. What is the resulting average force on the helicopter?

Reference no: EM13632432

Questions Cloud

Heights of trees in a forest are normally distributed the : heights of trees in a forest are normally distributed. the mean and standard deviation of a random sample of size 20
A mass less vertical spring is displaced 015 m when a 325 : a mass less vertical spring is displaced 0.15 m when a 3.25 kg mass is attached. when used horizontally what is the
In this activity students are asked to design a hypothesis : in this activity students are asked to design a hypothesis test collect data analyze the data and share a conclusion.
Saturated liquid water is compressed from 100 kpa state 1 : saturated liquid water is compressed from 100 kpa state 1 to 2.5 mpa state 2 in an adiabatic pump having 85 isentropic
An attack helicopter is equipped with a 20mm cannon tat : an attack helicopter is equipped with a 20mm cannon tat fires 112 g shells in the foward derection with a muzzle speed
Markings to indicate length are placed on a steel tape in : markings to indicate length are placed on a steel tape in a room that is at a temperature of 22degc. measurements are
The following table contains the probability distribution : the following table contains the probability distribution fornbspxnbsp the number of retransmissions necessary to
Calculate a the coal firing rate in lbhr b the fuel gas : a 500 mw coal-fired power plant is burning coal with a heating value of 12000 btulb. the coal contains 2.0 sulfur. the
A physics student throws a bowling ball straight up into : a physics student throws a bowling ball straight up into the air. the ball was in the air for a total of 8.44 seconeds

Reviews

Write a Review

Physics Questions & Answers

  How far does the car move during that time

A train 400m long is moving on a straight track with a speed of 84.30km/h. The engineer applies the brakes at the crossing and later the last car passes crossing with the speed of 17.7 km/h. suppose constant acceleration; conclude how long the tra..

  What is the intensity of the incident light

Unpolarized light is incident on a system of three polarizers. The second polarizer is oriented at an angle of 30 degrees with repect to the first, what is the intensity of the incident light

  What is the ideal mechanical advantage of a ramp

Two loudspeakers are placed 3-m apart. They emit 498 Hz sounds, in phase. A microphone is placed 3.2m distant from a point midway between the two speakers, where an intensity highest is recorded.

  What is the surface charge density on each plate

A parallel-plate air capacitor has a capacitance of 300 {\rm pF} and a charge of magnitude 0.250 \mu {\rm C} on each plate. The plates are 0.500 {\rm mm} apart. What is the surface charge density on each plate

  What was the speed of the bullet prior to impact

a 28 kg rifle bullet at an unknown velocity buries itself in a 3.6-kg pendulum hanging on a 2.8-m long string, what was the speed of the bullet prior to impact

  Find the magnitude of the magnetic flux contained in coil

A circular coil having an area of 24 cm^2 is plaved in a uniform magnetic field of 0.60T, which is derected vertically upward. Find the magnitude of the magnetic flux contained in the coil

  What is the temperature of the low-temperature reservoir

A Carnot engine whose high-temperature reservoir is at 680K takes in 570J of heat at this temperature in each cycle and gives up 350J to the low-temperature reservoir. What is the temperature of the low-temperature reservoir

  Evaluate the angular acceleration of the pulley

A block (mass = 2.0 kg) is hanging from a massless cord that is wrapped around a pulley (moment of inertia = 1.1 10-3 kg · m2), Find the angular acceleration of the pulley

  Compute the total angular momentum of the system

A horizontal circular platform rotates counterclockwise about its axis at the rate of 0.947 rad/s. Calculate the total angular momentum of the system

  Determine the speed of the water leaving the nozzle

A nozzle is now attached to the end of the hose. If the nozzle diameter is one-third the diameter of the hose, what is the speed of the water leaving the nozzle

  What is the minimum force needed to make crate start tipping

If the create has a mass of 110 and is 1.60 tall and 0.80 in depth and width, what is the minimum force needed to make the crate start tipping? (Assume the center of mass of the crate is at its center and static friction great enough to prevent sl..

  U-tube with constant cross section is partly filled water

A u-tube with constant cross section is partly filled with water. Engine oil of density 0.8g/cm3 is poured into the right arm (without mixing) until the water level rises 2.0cm. The length of the oil column is then.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd