After the initial cleanup effort at three mile island

Assignment Help Mechanical Engineering
Reference no: EM13704747

After the initial cleanup effort at Three Mile Island, approximately 400,000 gallons of radioactive water remained in the basement of the containment building of the Three Mile Island Unit 2 nuclear plant. The principal sources of this radioactivity were 137Cs at 156 J,t Cilcm3 and 134Cs at 26 J,tCilcm3 How many atoms per cm3 of these radio nuclides were in the water at that time?

Reference no: EM13704747

Questions Cloud

Diffusion in liquids commonly assumed a rigid sphere : Diffusion in liquids commonly assumed a rigid sphere in a continuum. When would this model be most accurate?.When could it fail? Diffusion varies with viscosity to the (+1) power in gases but to the (-1) power in liquids. Why?
Back-pressure steam turbine receives steam : A 20 MW back-pressure steam turbine receives steam at stagnation pressure of 4 MPa and stagnation temperature of 300oC, exhausting from the last stage at stagnation pressure of 0.35 MPa. The turbine isentropic efficiency is 0.884, and mechanical loss..
Volume of the container and the volume of the liquid phase : A container holds 10 kg of water at 130 *C with a quality of 4. What is the pressure in the container, the volume of the container, and the volume of the liquid phase?
Large hydraulic cylinder with a piston diameter : You have a large hydraulic cylinder with a piston diameter of 8.00 inches. The rod of the cylinder is extended 48 inches. The pressure inside the cylinder at time, t = 0.00 sec is 1,000 psig. There is a 10 foot long hose connected to the hydraulic cy..
After the initial cleanup effort at three mile island : After the initial cleanup effort at Three Mile Island, approximately 400,000 gallons of radioactive water remained in the basement of the containment building of the Three Mile Island Unit 2 nuclear plant. The principal sources of this radioactivity ..
The change in flow availability for compressor and turbine : An irreversible gas-turbine power plant has a compressor with an inlet state of 1 bar and 22°C and an outlet state of 4 bars and 470 K. The turbine has an inlet state of 4 bars and 1200 K and an exhaust state of 1 bar and 900 K. The environment is at..
Calculate the work for the entire process : A frictionless piston-cylinder contains 3.0 kg of H2O and is initially at 300 kPa. The initial volume is 1.0 m3. The water is heated until the temperature is 300 C. If the volume within the system reaches 1.5 m3, the piston hits a set of stops and is..
Assuming air to be an ideal gas : Assuming air to be an ideal gas, what would be the mass of air in a classroom of size 20 ft x 15 ft x 9 ft assuming the pressure inside the classroom is 1 atm and the classroom is at a constant temperature of 20^o C . Would the mass of gas inside the..
Advise jim as to his legal position : Advise Jim as to his legal position. Does a contract exist - case law and the relevant sections of any applicable legislation.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The velocity of the air stream decreases from 230 ms to 30

air at 80 kpa and 127 degrees celsius enters an adiabatic diffuser steadily at a rate of 6000 kghr and leaves at 100

  Wat is the time expression for the motor response if the

the 500 lbf motor is supported on springs with a total stiffness of 5000 lbfin. the springs have a damping ratio of

  Methane ch4 at 25 c 1 bar enters a furnace operating at

methane ch4 at 25 c 1 bar enters a furnace operating at steady state and burns completely with 140 of theoretical air

  A light pressure vessel is made of 2024-t3 aluminum alloy

a light pressure vessel is made of 2024-t3 aluminum alloy tubing with suitable end closures. this cylinder has a 3.50

  An insulated piston-cylinder device contains 3 liter of

an insulated piston-cylinder device contains 3 liter of saturated liquid water. the pressure is at 120kpa. now an

  Getting heat from a hot source that is 100 kpa steam going

getting heat from a hot source that is 100 kpa steam going from saturated vapor to a saturated liquid 1mw of power is

  What should be the rate of electrical heating in watts that

a tungsten wire 0.005mm in dia and 2 mm in length is placed horizontal in stagnant air. if we need to maintain the wire

  Te process begins with p1250 kpa and v115m3 and ends with

three kg of gas in a piston cylinder assembly undergo a process during which the relationship between pressure and

  The inner and outer glasses of a 12-m x 12-m double pane

the inner and outer glasses of a 1.2-m x 1.2-m double pane window are at 150c and 90c respectively. if the 6-mm space

  An ammonia absorption refrigeration cycle requires 2500

an ammonia absorption refrigeration cycle requires 2500 btulbm heat transfer in the generator.saturated vapor leaves

  A closed piston-cylinder with air expands and does 2000

a closed piston-cylinder with air expands and does 2000 ft-lbs of work. heat is added in the amount of 4 btu. what is

  How do you find the magnitude of individual vectors when

how do you find the magnitude of individual vectors when you have the magnitude of the resultant vector. after finding

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd