Reference no: EM133162263

Part I: Thus far at Acme Automotive Parts (AAP), you have determined that controls are required in the paint booths, at the hand-welding stations, and on the machining lines. You have also determined that you cannot substitute any alternate chemicals in these areas because of requirements from your clients. You decide to use general dilution ventilation for the machining lines and local exhaust ventilation systems for the paint booths and the hand-welding stations. Complete the following tasks.

For the general dilution ventilation used in the machining lines:

Discuss why you believe a general ventilation system is appropriate for this operation.

State where you would you place the fans associated with the ventilation system.

Explain how you would test the effectiveness of the ventilation system.

For the local exhaust ventilation systems:

Describe the local exhaust ventilations (LEVs) you would use for each area (paint booths and hand-welding stations).

Choose a hood type for each of the two LEVs.

Calculate the flow rate that would be required if you placed the LEV for the welding operation 24 in. from the weld and desired a capture velocity of 100 ft per minute (ft/min) given W=12 in. and L=24 in. for any of the three hood types.

Discuss any barriers you might face in implementing the use of the LEVs for these two operations.

Part II: You also determined that engineering controls are needed for the hydraulic press area.

Discuss some types of engineering controls that might be implemented for the hydraulic press area.

Describe the information you might require prior to designing engineering controls for the hydraulic press area.

Explain how you would evaluate the effectiveness of the engineering controls for this area.

Attachment:- Workplace Controls for Health Hazards.rar