Reference no: EM131220321
Sketch or draw the two-view drawing shown in Figure 18.45. Add the geometric dimensioning information per the following information:
a. Where the small cylinder intersects the large cylinder in the right side view, make the face on the larger cylinder datum feature D. Control this surface with a flatness tolerance of .005.
b. In the right side view, make the axis of the small cylinder datum feature E. The axis must be perpendicular within a .002 cylindrical tolerance zone at maximum material condition relative to datum feature D.
c. In the front view, make the .500-.505 slot datum feature F. Position this slot within a .003 tolerance zone at maximum material condition relative to primary datum feature D and secondary datum feature E at maximum material condition.
d. Make the 2.500 and 4.00 diameters basic dimensions.
e. Position the four small holes within a .005 cylindrical tolerance zone at maximum material condition relative to primary datum feature D, secondary datum feature E at maximum material condition, and tertiary datum feature F at maximum material condition.
f. Apply a profile of a surface tolerance of .050 to the outside surface in the front view relative to primary datum feature D and secondary datum feature E at maximum material condition.
|
Vertical axis and lattes on the horizontal axis
: Draw his budget line with burritos on the vertical axis and lattes on the horizontal axis. Make sure to carefully label your graph and all the relevant points.
|
|
Compensated based on both net income and cash flows
: You work at Delhaize. Your boss is compensated based on both Net Income and Cash Flows and wants to know the effect (direction and amount) that each of the following transactions would have on 2015 Net Income and 2015 Cash Flows. Delhaize signs a con..
|
|
Before tax and after tax cash flows
: Your model should show the before tax and after tax cash flows as well as the PV of the AFTC in each year and of course the NPV, which is the final solution. Your submission should include the model in ready to use clean version and a completed mo..
|
|
Find corresponding current and find interval
: The charge entering a certain circuit element is found to be q=5te-10tc. - find corresponding current and find interval t less then 0 at which current is minimum?
|
|
Add the geometric dimensioning information
: Where the small cylinder intersects the large cylinder in the right side view, make the face on the larger cylinder datum feature D. Control this surface with a fl atness tolerance of .005.
|
|
When actual gdp is above natural real gdp
: When actual GDP is above natural real GDP, is the value of actual unemployment rate above, below, or equal to the natural unemployment rate?
|
|
Currently in place in united states
: What rate of income tax from all level of government is currently in place in United States?
|
|
Find the oldest oceanic crust material
: Based on the information in the Bathymetry folder, at which placemark would you expect to find the oldest oceanic crust material?
|
|
Calculate elaines current basis in her partnership interest
: Elaine's original basis in the Hornbeam Partnership was $30,000. Her share of the taxable income from the partnership since she purchased the interest has been $90,000, and Elaine has received $80,000 in cash distributions from the partnership. Elain..
|