Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
What is a Look-up table? Which addressing mode is used for accessing Look-up tables in 8051?
Considering that the only parameters known are the input line-to-line voltage of 415V rms (f=50Hz), the firing angle (a= degrees) and the overlap angle (b=15degrees), calculate the Power Factor as seen from the input AC
A jet engine is modeled as a serial combination of a compressor, an adiabatic constant pressure combustor, and a turbine. Air (considered to have a variable specific heat) is compressed through a compression pressure ratio of 8.25:1
How many voice channels are carried by a E1 transmission given 8 kHz sampling and 8 bit words? Why is an end of frame marker always required in a digital telephony system?
Draw a circuit that operates as follows- When power is applied to the circuit and before any push buttons are pressed all relays are de-energised and lamps extinguished.
A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source. Calculate (a) the average and reactive powers delivered to the load, (b) the peak current, and (c) the load impedance.
What is the ONE independent variable in this study? What are the dependent variables and why is a one-way between-subjects MANOVA appropriate to use for this research design?
Design a circuit to generate a 20 kHz train of pulses with width proportional to an input voltage in the 0 - 5V range. You may use digital components such as clocks, counters and comparators.
1. which would have a higher line reactance in ohms. An overhead 138KV line or an overhead 34KV line. Why. 2. Does line charging amps increase or decrease with line length. Why
Suppose you have a 2 kW electric heater rated for 220 volt operation, which you intend to operate at a reduced power dissipation of 1kW. Calculate the proper amount of voltage you would need to achieve this reduced power dissipation
Why we can't store AC in Batteries instead of DC.or Can we store AC in batteries instead of DC?
A medium wave antenna mast is 50 m high and is operating at 1 MHz with a top loading the effective height is equal to 45 meters. with input power = 100 Kw , find the input current given that the ground resistance = 2.5 ohm .
You are designing a PCS base station that operates at 1800 MHz. The receiver is co-located on a tower with UHF police and business radio systems that operate at 450 MHz. Since the the 4th harmonic from the UHF system is directly in the PCS band
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd