A simple ideal ranking cycle has a power output

Assignment Help Mechanical Engineering

Reference no: EM13701085

A simple ideal ranking cycle has a power output of 660 MW, a turbine inlet condition of T1=1000F, P1=1800 psia and a condenser operating pressure of P2=1.5 psia.

Find:

a) The steam quality leaving the turbine, x2

b) The cycle thermal efficiency

c) The mass flow rate of steam (in lbm/hr)

d) The rate of heat rejection from the condenser (in Btu/hr)

Reference no: EM13701085

Questions Cloud

What is the power supplied to the cart : A 2 cm horizontal jet of water with a velocity of 15 m/s is spraying onto a vertical plate attached to a cart moving opposite the direction of the water jet at 8 m/s. Determine the force required to keep the cart moving at a constant velocity.

What is the exit air speed : Air enters a machine at 373 C with a speed of 200 m/s and leaves it at 293 C. If the flow is adiabatic, and the work output by machine is 105 Nm /kg, what is the exit air speed? What is the exit air speed when machine is delivering no work?

The pressure drop per unit length through the crack : A dam with water on one side has a 0.01 inch crack 10 feet below the surface of water. The length of the crack is 5 ft, and the thickness of the dam at that location is 3 ft. The water temperature is 50 degrees F. determine the following: The pressur..

An ideal single reheat cycle uses a turbine inlet conditions : An ideal single reheat cycle uses a turbine inlet conditions of 2500 psia and 1000F and a reheat temperature of 1000F with a reheat pressure ration of P2/P1 = 0.2 and a steam mass flow rate of Ms = 2*10^6 lbm/hr. The condenser operates at a pressure ..

A simple ideal ranking cycle has a power output : A simple ideal ranking cycle has a power output of 660 MW, a turbine inlet condition of T1=1000F, P1=1800 psia and a condenser operating pressure of P2=1.5 psia.

What is poisson ratio and shear modulus of this material : A 1 foot long cylindrical rod with a diameter of 0.25 inch is subjected to a tensile load of 1,500 lbs. Suppose the rod was elongated 0.01 inch under this load, what is the stress and strain created by the load? What is the Young’s Modulus of the mat..

What is the specific volume of the gas before the turbine : Air expands in an air turbine from a pressure of 50 psia and a temperature of 600Â°F to an exhaust pressure of 20 psia. Assume the process is reversible and adiabatic with negligible changes in kinetic and potential energy.

What is the specific heat capacity of this material : When a total amount of 125,000 joules of heat is transferred to a piece of 5 kg alloy, its temperature changes from 25 C to 60C, what is the specific heat capacity of this material?

A piston-cylinder setup filled with air : A piston-cylinder setup filled with air, initially at 27 °C, 1 bar, changes to 17 °C, and 0.9 bar. Determine, as a present, the change in volume of the air from its initial volume. (in %)

User Account

All Pages