Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A pre-engineering base line was run down a very steep hill.rather than measure horizontaily down hill with steel tape: surveyor measured the vertical angle with the theodolite and slope distance with 16m steel tape. The vertical angle was 21 degree and 26 minutes turned to a point on a plumbed range pole 1.5m above ground.The slope distance from the theodolite to the point on the range pole was 45.3m. The theodolites optical center was 1.4 m above the upper base line station at 110+71.25
a) If the elevation of the upper station was 253m, what is the elevation of lower point
b) What is chainage of the lower station
Determine the ASD reference and adjusted design values for the following members and loading conditions. All members are Select Structural Southern Pine and are fully braced to prevent lateral torsional buckling.
A Pelton wheel, located at an elevation of 200.0 m, is used to extract power from a reservoir at an elevation of 800 m. A penstock 1500 m long and 0.8 m in diameter connects the reservoir with the nozzle of the Pelton wheel.
Calculate the amount of water that will impact a five acre field from 5 inches of rainfall. Express the answer in gallons and cubic meters.
The cash flow associated with landscaping and maintaining a certain monument in Washington, D.C., is $100,000 now and $50,000 every 5 years forever. Determine its perpetual equivalent annual worth (in years 1 through infinity)
Find the magnitude and depth of the point of application of the force on the circular gate shown (circular gate at an angle of 60 deg.) if h(distance from top of gate to top of water)=5ft. and D(length of the gate)=4 ft.
The high point is at elevation 1011.4 ft. The initial grade is +2% and the final grade is -1%. What is the elevation of the PVT. Solve this problem with the parabolic equation rather than by using offsets.
A 230,000-lb space shuttle orbiter touches down at about 220 miles per hour (mph). At 200 mph, its drag parachute is deploys. The wheel brakes are applied at 100 mph until wheel sotp and the drag parachute is jettisoned from the orbiter at 35 mph.
A tank of Compressed oxygen for flame cutting is to contain 10 kg of oxygen at a preassure of 14 MPA ( the temperature is 20 degrees Celsius). How large must be the tank volume
The footing is supported to carry a net safe load of 400 kN/m^2 with FS = 3. Given Ysat = 20.85 KN/m^3 and phi = 35 degrees, find the required width of the footing using Terzaghi's general shear failure criterion.
The directional hourly traffic flow is 2000 vehicles with 5% large trucks and buses (no recreational vehicles). The total ramp density for this freeway segment is 2.33 ramps per mile. If peak hour factor is .90
A pneumatic-tired tractor with a 354 - hp engine has a maximum speed of 3.6 mph in 1st gear. Determine the max. rimpull of the tractor in each gear if the engine effieicency is 91%.
What is the maximum length of trench that can excavated by hand economically rather than by a trenching machine. it cost 900.00 to transport a trenching machine to the job and back to the storage yard
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd