Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A hot dog can be considered to be a cylinder 12 cm long and 2 cm in diameter whose properties are ρ= 980 kg/m^3, Cp = 3.9 kJ/kgoC, k = 0.76 W/moC, and α= 1.99x10^-7 m^2 /s. A hot dog initially at 4oC is dropped into boiling water at 100oC. If the heat transfer coefficient at the surface of the hot dog is estimated to be 680 W/m^2 oC, determine the center temperature of the hot dog after 5, 10 and 15 min by treating the hot dog as a finite cylinder.
With reference to basic constructional features, contrast the methods of compression employed by positive displacement and dynamic air compressors.
What load P allow can be supported at the midpoint of the bar if the yield stress in the steel wires is 220 MPa and in the aluminium wire is 80 MPa? A saftey factor of n = 2 is needed.
the cylinder is made from steel where yield stress= 240 MPa and v=0.3. Subsequently sketch the hoop and radial stresses in the wall of the cylinder.
consider a plane wall 100mm thick and of thermal conductivity 100 w/m .k seady state conditions are known to exist with T1 = 400 k T2= 600 K. determine the heat flux and the temperature gradient off the coordinate systems.
The rigid L-shaped member ABC is supported by a ball and socket at A and by three cables. Determine the tension in each cable and the reaction at A caused by the 242 kg load applied at G.
Remember that velocity is a vector quantity so find the magnitude of the average velocity and the angle of average velocity from the horizon
Consider the 2.0micrometer long GaAs device where the E-field is 5kV/cm and Mn*=.067M0. Calculate the transit time of an electron through the device if the mobility is 8000 cm^2V-s.
A turbine salesman makes the following claim for one of his products: Steam enters a steady-flow adiabatic turbine at 4 MPa, 600 °C with negligible velocity and exhausts at 200 kPa with a velocity of 180 m/s
Coal discharged from a dump truck with an initial velocity (v)= 1.8m/s at 50 degrees falls on conveyor belt B. Determine the required velocity v(B) of the belt if the relative velocity with which the coal hits the belt is to be vertical.
Determines if the member forces are in tension or compression (note that a negative number denotes compression and a position number denotes tension)
Hollow shaft transmitting power with shear limits. Design a hollow steel shaft to transmit 300 hp at 75 rpm without exceeding a shear tress of 8000 psi. Use 1.2:1 as the ratio of the outside diameter to the inside diameter.
Lift coefficient (Cl) and lift (L), An airfoil of surface area 1ft squared is tested for lift (L) in a wind tunnel. At an angle of attack of 5 degrees with standard air of density 0.0024 slugs/ft cube at a speed of 100 ft/sec
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd