A fuel oil is analyzed and found to contain 850 wt carbon

Assignment Help Mechanical Engineering
Reference no: EM13631670

A fuel oil is analyzed and found to contain 85.0 wt% carbon, 12.0% elemental hydrogen (H), 1.7% sulfur, and the remainder noncombustible matter. The oil is burned with 20.0% excess air, based on complete combustion of the carbon to CO2, the hydrogen to H2O, and the sulfur to SO2. The oil is burned completely, but 8% of the carbon forms CO. Calculate the molar composition of the stack gas.

Reference no: EM13631670

Questions Cloud

A researcher is interested in estimating the percentage of : a researcher is interested in estimating the percentage of us residents without health insurance. how large a sample is
If the maximum acceleration it experiences over the course : a mass oscillates on a horizontal frictionless surface as a result of being attached to a spring with k25 nm. it is
It is believed 30 of all adults are overweight how larger : it is believed 30 of all adults are overweight. how larger sample is necessary to estimate the true proportion of
Water flows in a 5-m-wide channel with a speed of 2 ms and : water flows in a 5-m-wide channel with a speed of 2 ms and a depth of 1m. the channel bottom slopes at a rate of 1 m
A fuel oil is analyzed and found to contain 850 wt carbon : a fuel oil is analyzed and found to contain 85.0 wt carbon 12.0 elemental hydrogen h 1.7 sulfur and the remainder
A blood test indicates the presence of a particulat disease : a blood test indicates the presence of a particulat disease 95 of the time when the disease is actually present. the
A coil is connected to a 60 hz ac generator with a peak : a coil is connected to a 60 hz ac generator with a peak emf equal to 80 v. at this frequency the coil has an impedance
The froude number changes from a subcritical value of 05 to : in flowing from section 1 to section 2 along an open channel the water depth decreases by a factor of 2 and the froude
A coil that has a resistance r and an inductance l has a : a coil that has a resistance r and an inductance l has a power factor equal to 0.866 when driven at a frequency of

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  However he does not record the direction of the flow show

a line worker takes the following measurements in a constant diameter pipe pa 200kpa za 56m pb 100kpa zb 68m.

  Determine the temperature at which the liquid

A rigid tank with a volum of 2.5m^3 contains 5kg of saturated liquid-vapor mixture of water at 75deg C. Now the water is slowly heated. Determine the temperature at which the liquid in the tank is completely vaporized

  Fnd the compressibility factor using a the generalized

1 given water vapor at 200 bar and 470oc.find the compressibility factor using a the generalized compressibility chart

  The gas turbine burns natural gas with a heating value of

a gas turbine has a pressure ratio of 15. it is connected to an electric generator with an efficiency of 95. the

  A hydrogen gas in a pistoncylinder assembly at 280k 100

a hydrogen gas in a pistoncylinder assembly at 280k 100 kpa with a volume of 0.1 m3 is now compressed to a volume of

  If initial and final pressures and volumes are the same as

a gas initially at pinitial 1 bar and occupying a volume vinitial of 1 liter is compressed within apiston-cylinder

  An ideal brayton cycle with regeneration has a pressure

an ideal brayton cycle with regeneration has a pressure ratio of 10. air enters the compressor at 300k and the turbine

  Calculate the brake kw of the fan if its efficiency is 65

a centrifugal fan is to be used to take a flue gas at rest zero velocity and at a temperature of 352.6 k and a pressure

  Use the perfomance characteristics of the marine propeller

total power required to overcome viscous resistance and wave drag is 11.4 mw. use the perfomance characteristics of the

  Taking the average thermal efficiency to be 362 percent

in the recent years the united states produced 50.8 percent of its electricity in the amount of 1.6181012 kwh from

  Evaluate the coefficient of performance assume cv for the

using the compressibility chart determine the volume in m3 occupied by 20 kg of hydrogen h2 at 11.55 atm and -364 degf.

  Calculate the number of vacancies per cubic meter in some

calculate the number of vacancies per cubic meter in some metal at 689degc. the energy for vacancy formation is 0.75

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd