A fan is to be selected to ventilate a bathroom whose

Reference no: EM13548164

A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise. The combined efficiency of the fan-motor unit to be used can be taken to be 50 percent. If the fan is to replace the entire volume of air in 10 min, determine

A) the wattage of the fan-motor unit to be purchased

B) the diameter of the fan casing

C) the pressure difference across the fan Take the air density to be 1.25 kg/m3 and disregard the effect of the kinetic energy correction factors.

Reference no: EM13548164

Questions Cloud

Determine the force in each member : The truss shown consists of 9 members and is supported by a ball and socket at A, two short links at B, and one short link at G. Check that this truss is a simple truss, that it is completely constrained

Determine the coefficient of statics friction between : A hawser is wrapped two full times around a bollard. by exerting an 80 pound force on the free end of the hawser a dockworker can resist a force of 5000 on the other end of the hawser.

Compute the value of pb in atm when h=10 m and density : A large closed tank is pressurized as shown. A jet of fluid issues from a small hole. Assume the flow is incompressible, irrotational, quasi-steady and the only body force acting is gravity.

Will there be any difference between the discharge velocitie : If a hose whose discharge end is left open on the ground is first connected to the lower valve and then to the higher valve, will there be any difference between the discharge rates of water for the 2 cases? Neglect frictional effects.

A fan is to be selected to ventilate a bathroom whose : A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise.

Determine the acceleration of the rod : A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.

Will the surveyor have to measure to locate the new station : Station 3 + 54.67 must be marked in the field. if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23..

There will be 3 hurricane-free years within the next 5 years : A 10-year hurricane is subjected to occur at a given region. Determine the probability that:

What percentage of the total load is carried by the shaft : What would be the load carrying capacity of a 250 mm-diameter and 15 m-long timber pile driven into soft clay with an unconfined compressive strength of 40 Kpa? What percentage of the total load is carried by the shaft?

User Account

All Pages