A dam spillway is tested with a 130th scale model matching

Assignment Help Mechanical Engineering
Reference no: EM13632475

A dam spillway is tested with a 1/30th scale model, matching the Froude number. The flow over the dam has an average velocity of 0.6 m/s and a volume flow rate of 0.08 m^3/s.

a. What will be the velocity and flow rate for the model?

b. If a force is measured on the model as 1.5 N, what is the corresponding force on the real dam?

Reference no: EM13632475

Questions Cloud

Barbra flynn is charge of maintaining hospital supplies at : barbra flynn is charge of maintaining hospital supplies at general hospital. during the past year the mean lead demand
In exercises 955-960 we have given the value obtained for : in exercises 9.55-9.60 we have given the value obtained for the test statistic z in one mean z-test. we have also
Use 005 solve the problem using both the critical region : the u.s. department of transportation national highway traffic safety administration reported that 77 of all fatally
The bullet passes through the block and emerges with its : a bullet with a mass of 7.00 g traveling horizontally with a speed of 400 ms is fired into a wooden block with mass of
A dam spillway is tested with a 130th scale model matching : a dam spillway is tested with a 130th scale model matching the froude number. the flow over the dam has an average
Assume that the paired data came from a population that is : assume that the paired data came from a population that is normally distributed. using a 0.05 significance level find
To what pressure in atm should the air in the wind tunnel : a model of an airplane is to be tested at 20degc in a wind tunnel. the model is built to 112th scale. in order to match
A single bolt is selected at random from 10000 three : a single bolt is selected at random from 10000. three different kinds of defects a b and c are known to occur in these
Is the national crime rate really going down some : is the national crime rate really going down? some sociologists say yes they say that the reason for the decline in

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Show that if the expansion of the gas that remains trapped

a long time ago the specific heat at constant volume of gases cv was determined indirectly from cp measurements and

  Determine the magnitude and direction fo the force p

A 200 kg crate is to be supported by the rope and pulley arrangement shown. Determine the magnitude and direction fo the force P that must be exerted on the freee end of the rope to maintain equillibrium.

  Find the height of stack in feet necessary for a driving

a powerplant is situated at an altitude of 1000 ft above sea level. flue gases enter the slack at 285 degree f and

  Air at 80f and standard atmospheric pressure flows through

air at 80f and standard atmospheric pressure flows through a furnace filter with an average velocity of 2.4 fts. the

  Consider a steam power plant that operates between the

consider a steam power plant that operates between the pressure limits of 5 mpa and 10 kpa. steam enters the pump as

  Consider a large cubic ice block floating in seawater the

consider a large cubic ice block floating in seawater. the specific gravities of ice and seawater are 0.92 and 1.025

  If the surroundings are treated as a thermal reservoir what

water in 50 liter rigid container is initially at 500 kpa and 350c. as the result of heat transfer the water obtains

  Determine a the components of the force f exerted by the

a nozzle discharges a stream of water of cross-sectional area a with a velocity va. the stream is deected by a single

  What is the temperature cm from the base

What is the temperature 7 cm from the base if the rod is made of a) pure zinc b) lead c) pure gold. Which will be the hottest at this point?

  A continuous gravity decanter is to separate chloro-benzene

a continuous gravity decanter is to separate chloro-benzene with a density of 1109 kgm3 from an aqueous wash liquid

  As the airplane begins its takeoff run at t 0 the normal

as the airplane begins its takeoff run at t 0. the normal forces exerted on its tires at a and b are na 4.2 kn and nb

  A jeep tows a 400kg block uip a 45deg incline the

a jeep tows a 400kg block uip a 45deg incline. the coefficients of friction between the block and the ground are us0.6

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd