A cylindrical tank of diameter

Assignment Help Mechanical Engineering

Reference no: EM13704546

A cylindrical tank of diameter 1 m has a well-rounded orifice of diameter 2 cm in its base. How long will it take an initial depth of acetone equal to 2 m to drain completely from the tank? How long would it take if the orifice were sharp-edged? If needed the density of acetone is 49.4 lbm/ft^3?

Reference no: EM13704546

Questions Cloud

A piston-cylinder device with a set of stops initially : A piston-cylinder device with a set of stops initially contains 0.6kg of steam at 0.8MPa and 500Â°C. The location of the stops corresponds to 60percent of the initial volume. Now the steam is cooled. Determine the compression work of the final state ..

Pitot-tube equation to determine the actual wind speed : A meteorologist uses a pitot -static tube to measure the wind speed in a tornado. Based on the damage caused by the storm, the tornado is rated as EF5 on the enhanced Fujita Scale. This means that the wind speed is estimated to be in the range of 261..

Compression processes in piston-cylinder devices : During some actual expansion and compression processes in piston-cylinder devices, the gases have been observed to satisfy the relationship PVn= C, where n and C are constants. Calculate the work done when a gas expands from 350 kPa and 0.03 m3 to a ..

Saturated water vapor : Five kilogram of saturated water vapor at 300 kPa is heated at constant pressure until its temperature reaches 200 oC. Calculate the work done by the steam during this process.

A cylindrical tank of diameter : A cylindrical tank of diameter 1 m has a well-rounded orifice of diameter 2 cm in its base. How long will it take an initial depth of acetone equal to 2 m to drain completely from the tank? How long would it take if the orifice were sharp-edged? If n..

Accounting for variation of specific heats with temperature : An air-standard Diesel cycle has a compression ratio of 18.2. Air is at 27°C and 100 kpa at the beginning of the compression process and at 1700 K at the end of the heat-addition process.

Consider an electric motor with shaft power output : Consider an electric motor with shaft power output of 20kW and an efficiency of 88%. Determine the rate at which the motor dissipates heat to the room it is in when the motor operates at full load. In winter, this room is normally heated by a 2-kW re..

Energy is required to melt cubic inch from room temperature : Given the melting point of steel to be approximately 1500 C, how much energy is required to melt a cubic inch from room temperature? How much water would this amount of energy raise by 10o C from room temperature?

Design a hollow steel shaft to transmit : Design a hollow steel shaft to transmit 225 kw of power at 80 rpm without exceeding a shearing stress of 60 MPa. Consider only torsion and assume that there are no stress concentrations. Make the ratio of the outside diameter to the inside diameter t..

User Account

All Pages