A cylinder with a moveable piston holds 20 lb of hydrogen

Assignment Help Mechanical Engineering
Reference no: EM13621239

A cylinder with a moveable piston holds .20 lb of hydrogen initially in a volume of 1 cu ft at a tem-perature of 1300 F. Then the volume is expanded to 2.5 cu ft while the gas pressure remains constant.

a. What is the initial gas pressure?

b. What is the final gas pressure?

c. Find the final gas temperature.

d. How much heat has been transferred to the gas?

e. What mechanical WORK has been done on the piston by the gas?

f. What has been the change in internal energy of the gas?

Reference no: EM13621239

Questions Cloud

A researcher examined rates of posttraumatic stress : a researcher examined rates of posttraumatic stress disorder ptsd in mothers and fathers. parents were interviewed 5
Industry analysts estimate that the replacement tire market : after extensive research and development goodweek tires inc. has recently developed a new tire the supertreadand must
A light fixture holds two lightbulbs bulb a is of a type : a light fixture holds two lightbulbs. bulb a is of a type whos lietime is nomally distributed with mean 800 hours and
The ends of the wire are attached to opposite ends of a : a 25 meter length of wire carrying a current of 8a lies on a horizontal table with a rectangular top of dimensions
A cylinder with a moveable piston holds 20 lb of hydrogen : a cylinder with a moveable piston holds .20 lb of hydrogen initially in a volume of 1 cu ft at a tem-perature of 1300
A flywheel within large water pump is a solid disk with : a flywheel within large water pump is a solid disk with mass 21 kg and a radius of 0.45 m. starting from rest it begins
What exactly is the patient asking about the test identify : a cardiologist has a device that measures prothrombin clotting times protimes of patients who are taking the blood
During this process the piston-cylinder system is : one kilogram of air is compressed polytropically n1.3 from a pressure of 100 kpa to a pressure of 1 mpa as the volume
Oxygen at a pressure temperature and volume of 40 psia 800f : oxygen at a pressure temperature and volume of 40 psia 800f and 20 ft3 undergoes a constant vol-ume process to a

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Determine the average applied force exerted on to the pile

determine the average applied force exerted on to the pile hammer. Note because the force is applied over a short time period it can be considered as an impulse force.

  A rankine cycle is to drive an electric generator to

a rankine cycle is to drive an electric generator to produce 600 mw of electricity. the generator is 95 efficient.the

  Calculate the velocity of air at the entry in fts the rate

a compressor pressurizes air from 1 atm to 2.38 atm at steady state. at the entry the airs temperature is 70f whereas

  A house has a composite wall of plaster board lp 10mm k072

a house has a composite wall of plaster board lp 10mm k0.72 wm.k fibre glass insulation lb100mm k1.4 wm.k and plywood

  Determine the boundary work per unit mass during the

2 kg of helium gas is initially contained in a rigid tank at 100 kpa and 27 c. the paddle wheel is now turned be an

  What is the formation volume factor of the oil

The separator produces 43,150 scf/d of 0.724 gravity gas, and the stock tank vents 7240 scf/d of 1.333 gravity gas. What is the formation volume factor of the oil? What is the solution gas-oil ratio? Which of the previous answers applies only at t..

  Find the value of the gain

Using MATLAB Simulink, set up the negative feedback system of and find the value of the gain

  What could be some of the strategies

How may data be managed to support a function (billing, human resources, accounting, finance, sales/marketing, training)?

  Compare this result with the heat loss if the window had a

a thermopane window consists of two 6-mm thick glasses separated by a stagnant air space of thickness 6 mm. the thermal

  Estimate the schmid factor

Estimate the Schmid Factor, which is used to convert the CRSS into a critical tensile 'yield' stress. Use the measured angle between the slip trace and the sample long axis

  Computing temperature water evaporation

Calculating temperature, water evaporation, and heat in a power plant cooling situation. In a nuclear power plant the cooling tower system must be run on a closed cycle.

  During the same 10 minutes heat transfer occurs at a

2kg of air in a closed rigid tank is fitted with an electrical resistor. the resistor draws a constant current of 10

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd