A charged oil droplet falls 4 mm in 180 s at terminal

Assignment Help Physics

Reference no: EM13629944

A charged oil droplet falls 4 mm in 18.0 s at terminal speed in the absence of an electric field. The specfic gravity of air is 1.35 multiplied by 10^-3, and that of the oil is 0.75. The viscosity of air is 1.80 multiplied by 10^-5 (N·s)/m².

(a) What is the radius of the drop?

(b) What is the mass of the drop?

(c) If the droplet carries 2 units of electric charge and is in an electric field of 2.5 multiplied by 105 V/m. what is the ratio of the electric force to the gravitational force on the droplet?

Reference no: EM13629944

Questions Cloud

The partition is now removed and the water expands to fill : a rigid tank is divided into two equal parts by a partition. one part of the tank contains 5.2kg of compressed liquid

Boron has a much lower coefficient of thermal expansion : boron has a much lower coefficient of thermal expansion than aluminum even though both are in the 3 b column of the

A speech signal has a total duration of 20 sec it is : a speech signal has a total duration of 20 sec. it is sampled at the rate of 8 khz and then pcm encoded. the

Water is sprayed radially outward over 180 degrees the jet : water is sprayed radially outward over 180 degrees. the jet is in the horizontal plane. if the jet velocity at the

A charged oil droplet falls 4 mm in 180 s at terminal : a charged oil droplet falls 4 mm in 18.0 s at terminal speed in the absence of an electric field. the specfic gravity

The unit cells of several orthorhombic crystals are : the unit cells of several orthorhombic crystals are described below. what is the bravais lattice of each and how do you

Calculate the energy of h2 molecule where nx ny nz - 10 : in general the quantization of transitional motion is insignificant for atoms because of their mass. however this

A tank whose volume is 001 m3 initially evacuated a pinhole : a tank whose volume is 0.01 m3 initially evacuated. a pinhole develops in the wall and the air from the surroundings at

Cutting speed is 60mmin chip load is 025mmtooth and depth : explain the tapping operation and the steps to follow peripheral milling is performed on the top surface of a

User Account

All Pages