A balloon filled with helium initially at 27 degree c and 1

Assignment Help Mechanical Engineering
Reference no: EM13626565

A balloon filled with helium, initially at 27 degree C and 1 bar. is released and rises in the atmosphere until the helium is at 17 degree C and 0.9 bar. Assuming that helium behaves as an ideal gas, determine the ratio of the final volume to the initial volume.

Reference no: EM13626565

Questions Cloud

Knowing that timber of 4-in nominal width 935-in actual : a 12-ft-long overhaning timber beam ac with an 8-ft span ab is to be designed to support the distributed and
Using a 60 cm focal length converging lens one wishes to : using a 60 cm focal length converging lens one wishes to obtain a virtual image which is four times as large as the
Determine the mass of air in the room in ibm the air : a fan drawing electricity at a rate of 1.5 kw is located in a room measuring 10 ft times 13 ft times 16 ft. the air in
A virtual image is formed by a convex mirror that has a 30 : a virtual image is formed by a convex mirror that has a 30 cm focal length. where must the object be placed if the
A balloon filled with helium initially at 27 degree c and 1 : a balloon filled with helium initially at 27 degree c and 1 bar. is released and rises in the atmosphere until the
A mass-spring system oscillates on a horizontal : a mass-spring system oscillates on a horizontal frictionless surface with an amplitude of 3.24 cm.a if the spring
1-kg of air at 200 kpa and 127 deg c is contained in a : 1-kg of air at 200 kpa and 127 deg c is contained in a piston-cylinder device. air is now allowed to expand in a
A lead bullet with a mass of 002 kg traveling at 198 ms : a lead bullet with a mass of 0.02 kg traveling at 198 ms strikes an armor plate and comes to a stop. if all the energy
A disk has a radius of 2 cm and weighs 12 kg what is the : a a disk has a radius of 2 cm and weighs 12 kg. what is the required constant moment to rotate the disk from rest to a

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  An insulation system is to be selected for a furnace wall

an insulation system is to be selected for a furnace wall at l000degc using first a layer of mineral wool blocks

  Calculate the reynolds number for water dynamic viscosity

calculate the reynolds number for water dynamic viscosity of 7.98 10-4 nsm2 flowing through a rectangular pipe 4 cm

  Consider a system in which r 134-a is moved through an

consider a system in which r 134-a is moved through an evaporator. the evaporator removes energy from the the

  What is the temperature at the center

Fireclay brick of dimensions 0.06 m x 0.09 m x 0.20 m is removed from a kiln at 1600 K and cooled in air at 40oC with h=50 W/m2/K. What is the temperature at the center and at the corners of the brick after 50 minutes of cooling?

  For the following given states find the reguired region ie

for the following given states find the reguired region i.e. phase or property of water.a given p 400kpa v 0.001084 m3

  Calculate the volume change associated with the change in

pure iron goes through a polymorphic change from bcc to fcc upon heating through 912degc. calculate the volume change

  Find the tension in ropes a and b

a 100 pound ball is suspended from a wall by a rope that is pulled asided by a horizontal rope B and held so that rope A makes a angle of 30 degrees with the vertical wall. Find the tension in ropes A and B?

  A satellite is in earth with an altitude at perigee of 550

a satellite is in earth with an altitude at perigee of 550 km and an altitude at apogee of 5000 kma what is the

  If upon initial null balance r3 is 1275 ohms and if when r2

a simple wheatstone bridge as shown in fig. 7.10 is used to determine accurately the value of an unknown resistance r1

  A stone of 20 kg of mass is held 15 m above a tank

a stone of 20 kg of mass is held 15 m above a tank containing 200 kg of water. the stone water and the air are at the

  A piston cylinder device contains 05 kg of water at 10mpa

a piston cylinder device contains 0.5 kg of water at 1.0mpa and 400oc. now it is cooled to 1mpa in sat-v phase.

  When the hydrofoil shown was tested the minimum pressure on

when the hydrofoil shown was tested the minimum pressure on the surface of the foil was found to be 70 kpa absolute

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd