A 1 kg mass is connected to a spring constant of 9 nm if

Assignment Help Physics
Reference no: EM13638308

A 1 kg mass is connected to a spring constant of 9 N/M. If the initial velocity is 4 cm /s and the initial displacement is 2 cm, then what is the maximum kinetic energy of the simple harmonic motion.

Reference no: EM13638308

Questions Cloud

Water is flowing in a 2cm radius pipe with a parabolic : water is flowing in a 2cm radius pipe with a parabolic velocity profile vxrvmax1-rro2 where ro is the radius of the
A pendulum is made with a 4 kg mass suspended at the end of : a pendulum is made with a 4 kg mass suspended at the end of a 75 cm thin rod. the pendulum started at an angle of 20
You are interviewing a candidate who has failed the test : the personnel department of a particular company has observed that 30 of the people the company hires are dismissed
Determine the systems coefficient of performance the power : an ideal vapor compression refrigeration cycle that uses r-134a maintains a pressure in the condenser of 1000kpa and
A 1 kg mass is connected to a spring constant of 9 nm if : a 1 kg mass is connected to a spring constant of 9 nm. if the initial velocity is 4 cm s and the initial displacement
The mass of the steam is 12 lb find the work in btu and the : steam in a piston cylinder assembly undergoes a polytropic process with n2 from an initial state of p500 psi v11.7
Assume the oil is a newtonian fluid and a linear velocity : a square-shaped board 1 m 1 m with weight of 16 n slides down a 30 o - inclined ramp with a terminal velocity of 22.5
The springs mass the recoil kinetic energy of the shuttle : you are asked to design a spring that will give a 1040 kg satellite a speed of 2.40 ms relative to an orbiting space
A batch of 50 different automatic typewriters contains : a batch of 50 different automatic typewriters contains exactly 10 defective machines. what is the probability of

Reviews

Write a Review

Physics Questions & Answers

  What would be the corresponding orbital radius

In the Bohr model, the electron is imagined to move in a circular orbit about a stationary proton. If the speed of the electron were7.9 multiplied by 105 m/s, what would be the corresponding orbital radius?

  Find at what angular frequency would it oscillate

A spring is compressed by 0.0748 m and is used to launch an object horizontally with a speed of 2.64 m/s. at what angular frequency (in rad/s) would it oscillate

  What is the motors power consumption

A certain electric motor draws a current of 46Awhen connected to 120 V. What is the motor's power consumption

  Calculate the maximum speed of the needle

in a needle biopsy, a narrow strip tissue is extracted from a patient using a hollow needle. rather than being pushed by hand, to ensure a clean cut the needle can be fired into the patient's body by a spring. calculate the maximum speed of the nee..

  Find the total momentum of the system

Given a system composed of three bowling balls (6.52 kg each) one sliding east at a velocity of 20m/second the second sliding north with a velocity of 35 m/sec, find the total momentum of the system

  Find how far above the diver does it appear to be

A skin diver is 1.8 m below the surface of a lake. A bird flies overhead 7.6 m above the surface of the lake. how far above the diver does it appear to be

  Evaluate how much heat is required

Argon is a monatomic gas whose atomic mass is 39.9 u. The temperature of 9 grams of argon is raised by 75 K under conditions of constant pressure. Assuming that argon is an ideal gas, evaluate how much heat is required? J

  Determine the change in the rate at which the following

pressurized water pin10bar ti110c enters the bottom of 10m vertical tube of d100mm at mass flow rate1.5 kgs. there is

  What is the maximum rotational speed

The Gravitron is an amusement park ride in which riders stand against the inner wall of a large spinning steel cylinder. At some point, What is the maximum rotational speed at which the riders will not slide up the walls of the ride

  Find the total displacement of the boat

A speedboat starts from rest and accelerates at +2.01 m/s2 for 6.95 s. At the end of this time, the boat continues for the additional 5.70 s with an acceleration of +0.518 m/s2. Following this, the boat accelerates at -1.49 m/s2 for 8.20 s.

  Find the difference in mass between the charged objects

Object A is metallic and electrically neutral. It is charged by induction so that it acquires a charge of -2.86E-6 C. Calculate the difference in mass between the charged objects

  How much energy did the heating element supply

A particular vacuum flask has a mass of 1 kilogram and contains 1 liter of liquid water, how much energy did the heating element supply, You can disregard the energy needed to warm and vaporize the water

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd