A 01 kg bullet fired from a rifle enters a very large body

Assignment Help Mechanical Engineering
Reference no: EM13631524

A 0.1 kg bullet fired from a rifle enters a very large body of water and comes to rest. As a result of aerodynamic drag, the bullet heats up significantly during flight; however, it cools off upon impact with the water. The flight velocity of the bullet as it enters the water is 500m/s and the entropy change of the water due to the cooling is 0.1kJ/K. Assuming the water has an avg temp of 25 degrees Celsius:

a) The temp of the bullet immediately before impact with the water given that the specific heat of the brass bullet is 0.38 kJ/kg-K. Make sure you watch your units carefully!

b) The total entropy generated by the cooling of the bullet.

Reference no: EM13631524

Questions Cloud

Explain qualitatively how it is possible for the electric : 1. explain qualitatively how it is possible for the electric field at locations near the center of a uniformly charged
Assume the above data represents the entire population of : an irate customer called dollar day mail order company 40 times during the last two weeks to see why his order had not
What is the best predicted iq of the older childgiven that : suppose iq score were obtained from a randomnly selected siblings.for such 20 pairs of people the linear corelation is
If the electric field exceeds about 3106 nc in air a spark : 1. if the electric field exceeds about 3106 nc in air a spark occurs. approximately what is the absolute value of the
A 01 kg bullet fired from a rifle enters a very large body : a 0.1 kg bullet fired from a rifle enters a very large body of water and comes to rest. as a result of aerodynamic drag
What is the best predicted iq of the older childgiven that : suppose iq score were obtained from a randomnly selected siblings.for such 20 pairs of people the linear corelation is
A long straight wire carries a conventional current of 09 : 1. a straight wire of length 0.62 m carries a conventional current of 0.8 amperes. what is the magnitude of the
If the maximum surface flaw size can be reduced to 30 mm : a component is fabricated from an aluminum alloy that has a plane strain fracture toughness of 43 mpa-m-12. during
Steam generator tube denting is caused by rusting tube : steam generator tube denting is caused by rusting tube support plates which in turn is caused by acid chloride attack.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A drill operation is to be performed with a 16 mm twist

a drill operation is to be performed with a 16 mm twist drill the hole is blind with a depth of 50 mm.cutting speed is

  The net force applied by the belt on the pulley is 2000 n

the driveshaft of a buildings air-handling fan is turned at 300 rpm by a belt running on a 0.3- m-diameter pulley. the

  Determine the magnitude of the load p

Knowing that the modulus of elasticity of brass is 105 GPa, determine the magnitude of the load P for which the deflection of the plug is 1,25 mm downward.

  On top of the water is 03 m of kerosene which is open to

water occupies the bottom 0.8 m of a cylindrical tank. on top of the water is 0.3 m of kerosene which is open to the

  A thick cylindrical sleeve when shrunk onto a hollow shaft

a thick cylindrical sleeve when shrunk onto a hollow shaft of a different material had its internal diameter extended

  If the tank is well insulated what will be the pressure in

a 0.2 m3 tank containing helium at bar and 22 c will be used to supply 4.5 moles per minute of helium at atmospheric

  A spring-mass-damper system is subjected to a harmonic

a spring-mass-damper system is subjected to a harmonic force. the amplitude is found to be 20mm at resonance and 10mm

  During the construction of a highway by-pass earthmoving

during the construction of a highway by-pass earthmoving equipment costing 40000 was purchased for use in transporting

  Consider a large classroom on a hot summer day with 150

consider a large classroom on a hot summer day with 150 students each dissapating 60w of sensible heat. all the lights

  The r-134a is then heated to a final temperature of 30

r-134a is contained in a vertical cylinder fitted with a frictionless piston and a set of stops and the volume is

  The electrical resistivity of 90wt cu-10wt ni cupronickel

the electrical resistivity of 90wt. cu-10wt. ni cupronickel alloy at room temperature is 16x10-8?.m. the electrical

  Find the magnitdue of the acceleration when it reaches

a sled is traveling down a curve which can be approxmiated by a parabola y .01x2. find the magnitdue of the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd