1 a watershed contains 162 ha and 243 ha of agricultural

Assignment Help Civil Engineering
Reference no: EM13375413

1. A watershed contains 16.2 ha and 24.3 ha of agricultural and residential land use, respectively. The last rainfall removed all P accumulations and was followed by a 2 day dry period before a 12.7mm rain event with duration = 60 min., P loading rate for agricultural land use = 1,656 g/day, P loading rate for residential land use = 1.8 kg/ha/yr, determine:

(i) the initial P load in grams.

(ii) the average P concentration in the runoff if the overall (agricultural and residential areas) runoff coefficient = 0.4, 40% of P is removed from the agricultural area by rainfall, and 90% of P is removed from the residential area by rainfall.

(iii) the concentration of P (mg/L) after the first 10 minutes of runoff assuming that the amount washed off from the residential and agricultural areas follows a first order reaction:

P0 - Pt = P0(1 - e-kRT)

where Po is the initial loading (kg), Pt is the mass remaining after time t, k = 0.181 mm-1 and R (mm/hr) is the rainfall excess. Assume that the volume runoff after 10 min is 0.4 x 106L.

2. The direct runoff measured for a storm event for a catchment, with an impervious area of 500 ha is provided in the table below. Given that the rate of change of solids remaining is proportional to the solids remaining, or dP/dt = kP where P (kg) is the weight of solids, t (hr) is time and k = 2 cm-1 and the initial mass Po = 2,000 kg, derive the pollutograph and the loadograph.

1475_Derive the pollutograph and the loadograph.png

3. An urban residential area is estimated to have I = 40%, average annual rainfall of 1,320mm and it is estimated that 50% of rainfall does not produce runoff. Using the EMC listed in Table 9.3, estimate the median and 90th percentile load of SS contained in the runoff. Note: COV = coefficient of variance (= sd/mean), x90 = μ + 1.28sd.

59_Derive the pollutograph and the loadograph1.png

Reference no: EM13375413

Questions Cloud

Using the regression results and the other computations : using the regression results and the other computations from assignment 1 determine the market structure in which the
Problem set one1-price-elasticity : problem set one1-price-elasticity of
Incomesales 4000000interest income 100000 of tax-exempt : incomesales 4000000interest income 100000 of tax-exempt interest other than from specified private activity bonds
Read periodicals or on the internet to find out more about : read periodicals or on the internet to find out more about the sarbanes-oxley acts provisions for companies. select one
1 a watershed contains 162 ha and 243 ha of agricultural : 1. a watershed contains 16.2 ha and 24.3 ha of agricultural and residential land use respectively. the last rainfall
Prepare a return on investment analysis for the regional : prepare a return on investment analysis for the regional manager of out-and-in burgers. this growing chain is trying to
Trace the evolution of work on the laissez-faire doctrine : trace the evolution of work on the laissez-faire doctrine through two arcs. first those theorists who are trying to
Review the roles of management accounting within a company : review the roles of management accounting within a company. what is the most important role of management accounting?
Adam smith rejected utility as a foundation for value he : adam smith rejected utility as a foundation for value. he illustrates this rejection in his famous diamonds and water

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum allowable axial tensile force

A 4-cm- diameter rod of aluminum 7075-T6 is to subjected to an axial tensile force such that the factor of safety based on the yield stress on 1.75. Find the maximum allowable tensile force.

  What is the difference in elevation between the two points

In determining the difference between points A and B, the inclined distance was measured to be 157.65 ft. The transit was set u on point A. The height of its transverse axis was 5.2 ft about point A

  What is the smallest particle size that will be removed

What is the smallest particle size (density 2.65 g/cm3) that will be removed in a horizontal grit chamber 10 m long and 1.0 m deep if the flow rate is 1000 m3/hr. Assume the temperature of the water is 25°C.

  What is the width of the second floor

A cross section of a cottage, 20 ft wide, is an isosceles triangle. If the slope of a side is 1.75 and there is a second floor 8 ft above the ground floor, what is the width of the second floor?

  Write a paper on steel sustainability - how to do design

write a paper on steel sustainability. - how to do design calculations for penthouse in steel building and- why the

  Determine poissons ratio and the new length of the 2-in side

The aluminum block has a rectangular cross section and is subjected to an axial compressive force of 8kip. If the 1.5-in side changed its length to 1.500132 in., Determine Poisson's ratio and the new length of the 2-in side.

  Determine the percent finer than each sieve

Determine D10, D30, and D60Effective grain size c. Cu d. Cz Sieve Number Opening (mm) Mass of soil retained (g) No. 4 4.750 28 No. 10 2.000 42 No. 20 0.850 48 No. 40 0.425 128 No. 60 0.250 221 No. 100 0.150 86 No. 200 0.075 40 Pan 24

  How far does a horizontal plane depart from a level surface

The width of a lake is 16 km (it is a flat plane tangent to the radius of the sphere). How far does a horizontal plane depart from a level surface if the earth is a sphere with r=6371km

  Determine what is the discharge in cubic feet per second

A 2 foot tall multi-stage weir placed in a channel to cause the water to flow over the contracted weir at a height of 0.75 feet. There are 2 contractions and the original length is 6 feet. What is the discharge, in cubic feet per second

  Determine an appropriate pipe diameter and slope for reach

Determine an appropriate pipe diameter and slope for this reach, and establish the pipe invert elevations at the upper and lower manholes. Assume that a minimum earth cover of 2 m above the pipe crown is required.

  How far apart in nautical miles are ships at the time

ship A leaves port sailing in a direction 60 degree C north of due east and sails for 12 hours at 10 knot . Sheep B leaves the same port 3 hours later and sails due east at 25 knot for 9 hours.

  Calculate value of temperature that can increase efficiency

An engineering student, recognizing that the "ideal gas law" requires gas velocity to be function of temperature, suggests that an easy way to increase efficiency would be to change the temperature of the exhaust gas being treated.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd